Juniper NetworksCertified Professional, Security (JNCIP-SEC)
Domain 7Objective 6
Active/active Mode JN0-637 Practice Questions (Page 1)
Part of the Multinode High Availability (HA) domain, which makes up ~22% of our current practice bank. Juniper Networks does not publish an official question count, but from its 90-minute exam (~35–60 total, ~8–13 in this domain), expect 1–2 from this objective — we provide 18 practice questions to prepare you well beyond it. (estimate)
18questions here
4free pages
6concepts
Questions 1–5
- 1
Which log file would you examine to troubleshoot chassis cluster issues?
Select an answer first - 2
What is the purpose of session synchronization in active/active mode?
Select an answer first - 3
An engineer is troubleshooting an active/active chassis cluster. They run 'show chassis cluster status' and see that RG1 is primary on node0 and RG2 is primary on node1. However, they observe that all traffic is being forwarded by node0. They run 'show chassis cluster interfaces' and see that the interfaces for RG2 are listed as 'down' on node1. What is the most likely cause?
Select an answer first - 4
Which configuration element is used to assign interfaces to a specific node in a chassis cluster?
Select an answer first - 5
A network engineer is configuring a chassis cluster on two SRX345 devices. They have created redundancy group 1 (RG1) and assigned two redundant Ethernet interfaces to it. They want to verify that the interfaces are correctly configured for the cluster. Which command should they use?
Select an answer first
Finished these 5 questions?
Review the revealed explanations, or continue through the curriculum.
Free Basic Practice is a study aid with revealable answers — not a scored exam. Examers.io is independent and not affiliated with or endorsed by Juniper Networks. “JN0-637” is a trademark of its owner, used for identification only.