Device States JN0-481 Practice Questions (Page 4)

Questions 16–20

1. 16foundation · easy

   What corrective action might you take after identifying that a device is in an error state due to a configuration failure?

   • ADelete the device from the fabric and re-add it
   • BChange the device's state to 'active' manually
   • CWait for the device to recover on its own
   • DReapply the correct configuration to the device
   Reveal Solution Discussion Select an answer first
2. 17application · medium

   An administrator is reviewing the device states in an Apstra blueprint and sees that a leaf switch is in the 'inactive' state. What does this state indicate about the device?

   • AThe device is not currently part of any active blueprint but remains in Apstra's inventory
   • BThe device is in the process of being onboarded and has not yet been configured
   • CThe device is actively forwarding traffic but has a minor configuration warning
   • DThe device has failed its connectivity probes and is unreachable
   Reveal Solution Discussion Select an answer first
4. 18application · medium

   A network administrator is looking at the Apstra UI and wants to see a summary of all device states across the entire fabric. Which view provides this information at a glance?

   • AThe device inventory view
   • BThe audit log view
   • CThe device state dashboard in the blueprint view
   • DThe topology view with all devices expanded
   Reveal Solution Discussion Select an answer first
5. 19expert · hard

   An engineer is troubleshooting a device that is stuck in an 'error' state even after the underlying issue has been resolved. The device is reachable and all probes are passing when checked manually. What is the most likely reason the device remains in an error state?

   • AThe device needs to be rebooted to clear the error state
   • BThe error state is permanent and cannot be cleared
   • CThe device must be removed from the blueprint and re-added
   • DApstra has not yet re-run its probes to update the device state
   Reveal Solution Discussion Select an answer first
6. 20application · medium

   A network operator notices that a specific leaf device is repeatedly transitioning between 'active' and 'error' states every few minutes. The device is reachable via SSH. What is the most likely cause of this flapping behavior?

   • AThe device's configuration is being changed externally, causing Apstra to detect drift
   • BThe device is overloaded and dropping management traffic
   • CIntermittent connectivity issues between the device and the Apstra server, causing probes to fail intermittently
   • DThe device is being rebooted by another administrator
   Reveal Solution Discussion Select an answer first