Juniper NetworksCertified Specialist, Service Provider Routing and Switching (JNCIS-SP)
Domain 5Objective 9
Configure, Monitor, or Troubleshoot Interfaces, Ports, and VLANs JN0-364 Practice Questions (Page 2)
Part of the Layer 2 Bridging and VLANs domain, which makes up ~11% of our current practice bank. Juniper Networks does not publish an official question count, but from its 90-minute exam (~35–60 total, ~4–7 in this domain), expect 1–1 from this objective — we provide 11 practice questions to prepare you well beyond it. (estimate)
11questions here
3free pages
5concepts
Questions 6–10
- 6
Two EX4300 switches are connected via a trunk link. Hosts on VLAN 10 can communicate within the same switch, but not across the link. 'show interfaces ge-0/0/0' on both switches shows the link is up. 'show vlans' on Switch A shows VLAN 10 with ge-0/0/0 as a member. Switch B shows VLAN 10 with ge-0/0/0 as a member. What is the most likely cause of the issue?
Select an answer first - 7
Which command displays the VLAN configuration, including VLAN names and IDs, on a Junos OS device?
Select an answer first - 8
Which command is used to verify the VLAN membership of all interfaces on a Junos OS switch?
Select an answer first - 9
Which command shows the operational state and VLAN membership of a specific interface on a Junos OS switch?
Select an answer first - 10
Which command would you use to check if an interface is operationally down on a Junos OS switch?
Select an answer first
Finished these 5 questions?
Review the revealed explanations, or continue through the curriculum.
Free Basic Practice is a study aid with revealable answers — not a scored exam. Examers.io is independent and not affiliated with or endorsed by Juniper Networks. “JN0-364” is a trademark of its owner, used for identification only.