Juniper NetworksCertified Specialist, Service Provider Routing and Switching (JNCIS-SP)
Domain 10Objective 8
Configure, Monitor, or Troubleshoot High Availability Features JN0-364 Practice Questions (Page 4)
Part of the High Availability domain, which makes up ~12% of our current practice bank. Juniper Networks does not publish an official question count, but from its 90-minute exam (~35–60 total, ~4–7 in this domain), expect 1–1 from this objective — we provide 25 practice questions to prepare you well beyond it. (estimate)
25questions here
5free pages
9concepts
Questions 16–20
- 16
A network operator is troubleshooting a BGP session that flaps intermittently. The session is established over a 10 Gbps link with a 100 ms propagation delay. The operator suspects that the failure detection time is too slow. Which configuration change would most directly reduce the time to detect a link failure?
Select an answer first - 17
Which log or operational command would you use to diagnose issues with BFD sessions on a Juniper device?
Select an answer first - 18
Which operational command would you use to verify the status of GRES on a Juniper device?
Select an answer first - 19
A service provider has two MX204 routers configured as a VRRP group. The master router is also the primary for a BGP session to an upstream provider. The engineer notices that when the master router fails, the backup router takes over the virtual IP but does not have the BGP session to the upstream provider. What is the most likely cause?
Select an answer first - 20
What is the primary purpose of Nonstop Bridging (NSB) on Juniper devices?
Select an answer first
Finished these 5 questions?
Review the revealed explanations, or continue through the curriculum.
Free Basic Practice is a study aid with revealable answers — not a scored exam. Examers.io is independent and not affiliated with or endorsed by Juniper Networks. “JN0-364” is a trademark of its owner, used for identification only.