Juniper NetworksCertified Specialist, Enterprise Routing and Switching (JNCIS-ENT)
Domain 5Objective 2
OSPF Configuration and Troubleshooting JN0-352 Practice Questions (Page 1)
Part of the OSPF domain, which makes up ~4% of our current practice bank. Juniper Networks does not publish an official question count, but from its 90-minute exam (~35–60 total, ~1–2 in this domain), expect 1–1 from this objective — we provide 11 practice questions to prepare you well beyond it. (estimate)
11questions here
3free pages
7concepts
Questions 1–5
- 1
Which Junos operational command displays the OSPF interface cost, state, and neighbor count for all OSPF-enabled interfaces?
Select an answer first - 2
Which command would you use to verify the OSPF neighbor state and identify if a router is stuck in the Init state?
Select an answer first - 3
Which OSPF interface parameter is used to influence the selection of the Designated Router (DR) on a broadcast network?
Select an answer first - 4
Which Junos command would you use to trace OSPF hello packet exchanges to diagnose neighbor formation issues?
Select an answer first - 5
Two OSPF routers are connected via a point-to-point link. The link is up, but the routers are not forming a neighbor relationship. The engineer checks the OSPF interface configuration and finds that Router A is in area 0 and Router B is in area 1. Which command will confirm this as the cause?
Select an answer first
Finished these 5 questions?
Review the revealed explanations, or continue through the curriculum.
Free Basic Practice is a study aid with revealable answers — not a scored exam. Examers.io is independent and not affiliated with or endorsed by Juniper Networks. “JN0-352” is a trademark of its owner, used for identification only.