Chassis Cluster Characteristics and Operation JN0-336 Practice Questions (Page 4)

Questions 16–20

1. 16application · medium

   A security team is deploying a pair of SRX Series devices as a chassis cluster. During the initial bring-up, they notice that node0 is consistently holding the primary role for all redundancy groups, even after a manual failover is triggered. The team wants to ensure that node1 can take over if node0 experiences a hardware failure. What should they do?

   • AConfigure a higher priority value for node1 on the redundancy groups.
   • BDisable the control link on node0 to force node1 to become primary.
   • CReboot node1 to force it to renegotiate for primary role.
   • DSet the failover mode to 'manual' on the redundancy groups.
   Reveal Solution Discussion Select an answer first
2. 17foundation · easy

   What is the primary purpose of a chassis cluster in Junos OS?

   • ATo combine multiple devices into a single logical device for increased throughput
   • BTo enable centralized management of multiple standalone devices from a single interface
   • CTo allow multiple devices to operate as independent routers while sharing a single control plane
   • DTo provide high availability by pairing two devices that share configuration and state, with one actively forwarding traffic
   Reveal Solution Discussion Select an answer first
4. 18foundation · easy

   Which command is used to monitor the health of the control link in a chassis cluster?

   • Ashow chassis cluster data-plane statistics
   • Bshow chassis cluster interfaces
   • Cshow chassis cluster redundancy-group
   • Dshow chassis cluster control-plane statistics
   Reveal Solution Discussion Select an answer first
5. 19foundation · easy

   How many redundancy groups are supported by default in a Junos chassis cluster?

   • AUnlimited
   • BTwo
   • COne
   • DUp to 128
   Reveal Solution Discussion Select an answer first
6. 20expert · hard

   A company is running a chassis cluster with two nodes. They are experiencing high latency on traffic that is being forwarded from the backup node to the primary node. The fabric link is configured as a single 1G link. The administrator wants to improve performance. What is the most effective solution?

   • AAdd an additional fabric link to increase bandwidth.
   • BIncrease the priority of the backup node.
   • CConfigure the fabric link as a control link.
   • DDisable the fabric link and use the control link for data plane traffic.
   Reveal Solution Discussion Select an answer first