What type of traffic is carried over the control link in a Junos chassis cluster?

Heartbeat messages and control traffic

Management traffic from the network

Data plane traffic between nodes

What is the purpose of a redundancy group in a chassis cluster?

To manage the configuration synchronization between nodes

To group multiple interfaces and services that fail over together as a unit

To provide a backup for the control link

To assign IP addresses to redundant interfaces

A network engineer is setting up a chassis cluster for the first time. They have two SRX devices that are physically connected via a control link and a fabric link. They have configured the cluster ID and node ID on both devices. What is the next step to complete the cluster formation?

Commit the configuration on both devices.

Set the fabric link as the control link.

Configure the redundancy groups.

Which of the following is a required configuration step when setting up a chassis cluster?

Setting up a routing protocol between the nodes

Assigning a node ID to each device

Configuring a virtual IP address for the cluster

Juniper NetworksCertified Specialist, Security (JNCIS-SEC)

Domain 4Objective 3

Chassis Cluster Characteristics and Operation JN0-336 Practice Questions (Page 1)

Part of the High Availability (HA) Clustering domain, which makes up ~14% of our current practice bank. Juniper Networks does not publish an official question count, but from its 90-minute exam (~35–60 total, ~5–8 in this domain), expect 1–2 from this objective — we provide 21 practice questions to prepare you well beyond it. (estimate)

21questions here

5free pages

9concepts

Questions 1–5

1foundation · easy
Which command is used to display the status of a chassis cluster?
Select an answer first
2foundation · easy
What type of traffic is carried over the control link in a Junos chassis cluster?
Select an answer first
3foundation · easy
What is the purpose of a redundancy group in a chassis cluster?
Select an answer first
4application · medium
A network engineer is setting up a chassis cluster for the first time. They have two SRX devices that are physically connected via a control link and a fabric link. They have configured the cluster ID and node ID on both devices. What is the next step to complete the cluster formation?
Select an answer first
5foundation · easy
Which of the following is a required configuration step when setting up a chassis cluster?
Select an answer first

Finished these 5 questions?

Review the revealed explanations, or continue through the curriculum.

Next 5 questions →Back to JN0-336

Free Basic Practice is a study aid with revealable answers — not a scored exam. Examers.io is independent and not affiliated with or endorsed by Juniper Networks. “JN0-336” is a trademark of its owner, used for identification only.