You are configuring a chassis cluster and need to ensure that the cluster can be managed via a single IP address. What configuration is required?

Configure the control link with an IP address.

Configure the cluster ID and node IDs only.

Configure a redundant Ethernet (reth) interface with a virtual IP address.

Configure the same IP address on both nodes' management interfaces.

You are monitoring a chassis cluster and notice that the redundancy group 1 is in the 'primary' state on node 1 and 'standby' on node 2. What does this indicate?

Both nodes are actively handling traffic for redundancy group 1.

Node 1 is actively handling traffic for redundancy group 1.

The redundancy group is not functioning correctly.

Node 2 is actively handling traffic for redundancy group 1.

You are configuring a chassis cluster and need to ensure that the cluster can pass traffic even if one node fails. What is the minimum number of fabric interfaces required?

One fabric interface on the primary node only.

Two fabric interfaces per node.

Two fabric interfaces on the primary node only.

What does the 'show chassis cluster interfaces' command display?

The configuration of all interfaces on both nodes

The status of the control link and fabric link

The traffic statistics for all interfaces

The redundancy group states for all interfaces

In a Junos chassis cluster, what is the role of the node with the higher node ID?

It is always the secondary node.

It is the node that holds the cluster configuration.

It has no inherent role; the role is determined by redundancy group priority.

Juniper NetworksCertified Specialist, Security (JNCIS-SEC)

Domain 4Objective 5

Configure, Monitor, or Troubleshoot Clustering JN0-336 Practice Questions (Page 1)

Part of the High Availability (HA) Clustering domain, which makes up ~14% of our current practice bank. Juniper Networks does not publish an official question count, but from its 90-minute exam (~35–60 total, ~5–8 in this domain), expect 1–2 from this objective — we provide 10 practice questions to prepare you well beyond it. (estimate)

10questions here

2free pages

3concepts

Questions 1–5

1application · medium
You are configuring a chassis cluster and need to ensure that the cluster can be managed via a single IP address. What configuration is required?
Select an answer first
2application · medium
You are monitoring a chassis cluster and notice that the redundancy group 1 is in the 'primary' state on node 1 and 'standby' on node 2. What does this indicate?
Select an answer first
3application · medium
You are configuring a chassis cluster and need to ensure that the cluster can pass traffic even if one node fails. What is the minimum number of fabric interfaces required?
Select an answer first
4foundation · easy
What does the 'show chassis cluster interfaces' command display?
Select an answer first
5foundation · easy
In a Junos chassis cluster, what is the role of the node with the higher node ID?
Select an answer first

Finished these 5 questions?

Review the revealed explanations, or continue through the curriculum.

Next 5 questions →Back to JN0-336

Free Basic Practice is a study aid with revealable answers — not a scored exam. Examers.io is independent and not affiliated with or endorsed by Juniper Networks. “JN0-336” is a trademark of its owner, used for identification only.