Juniper NetworksCertified Associate, Data Center
Domain 3Objective 6
Static Route and Load-Balancing Configuration and Monitoring JN0-281 Practice Questions (Page 1)
Part of the Protocol-Independent Routing domain, which makes up ~16% of our current practice bank. Juniper Networks does not publish an official question count, but from its 90-minute exam (~35–60 total, ~6–10 in this domain), expect 1–2 from this objective — we provide 7 practice questions to prepare you well beyond it. (estimate)
7questions here
2free pages
4concepts
Questions 1–5
- 1
Which command shows the distribution of traffic across equal-cost paths in the forwarding table?
Select an answer first - 2
You have configured two static routes to the same destination with the same preference, creating an ECMP set. You want to verify that the device is actually using both paths for forwarding. Which command would you use to confirm the ECMP behavior?
Select an answer first - 3
You have configured load balancing across two equal-cost paths on your Junos device. You want to ensure that traffic from a specific application is always sent over the same path to avoid out-of-order packets. Which load-balancing method should you use?
Select an answer first - 4
You configured a static route on a Junos device and want to verify that it is installed in the routing table. Which command shows the route and its next-hop?
Select an answer first - 5
You have configured per-flow load balancing across two equal-cost paths on your Junos device. After monitoring the traffic, you notice that one path is carrying significantly more traffic than the other. What is the most likely cause?
Select an answer first
Finished these 5 questions?
Review the revealed explanations, or continue through the curriculum.
Free Basic Practice is a study aid with revealable answers — not a scored exam. Examers.io is independent and not affiliated with or endorsed by Juniper Networks. “JN0-281” is a trademark of its owner, used for identification only.