Initial Configuration JN0-232 Practice Questions (Page 2)

Questions 6–10

1. 6foundation · easy

   Which command is used to set the hostname on an SRX Series device?

   • Aset system host-name SRX1
   • Bset system name SRX1
   • Cset hostname SRX1
   • Dset system hostname SRX1
   Reveal Solution Discussion Select an answer first
2. 7foundation · easy

   What is the purpose of source NAT on an SRX Series device?

   • ATo translate private IP addresses to public addresses for outbound traffic.
   • BTo encrypt traffic between two sites.
   • CTo translate public IP addresses to private addresses for inbound traffic.
   • DTo filter traffic based on source and destination addresses.
   Reveal Solution Discussion Select an answer first
4. 8application · easy

   An administrator has just set the root password on a new SRX300 using the CLI. The administrator wants to ensure the password change survives a reboot. What must be done next?

   • AIssue the `save` command.
   • BReboot the device immediately.
   • CIssue the `commit` command.
   • DCopy the configuration to a USB drive.
   Reveal Solution Discussion Select an answer first
5. 9foundation · easy

   What is the default action of a security policy on an SRX Series device if no policy matches?

   • ALog
   • BDeny
   • CReject
   • DPermit
   Reveal Solution Discussion Select an answer first
6. 10foundation · easy

   Which statement accurately describes the factory default configuration of an SRX Series device?

   • AThe ge-0/0/0 interface is assigned to the trust zone, and a default policy denies all traffic.
   • BThe device is configured with a default root password of 'juniper'.
   • CAll interfaces are assigned to the trust zone by default.
   • DThe device has a default security policy that permits all traffic between zones.
   Reveal Solution Discussion Select an answer first