Initial Configuration JN0-232 Practice Questions (Page 1)

Questions 1–5

1. 1foundation · easy

   Which command creates a security zone named 'trust' on an SRX Series device?

   • Aset security zone trust
   • Bset zones security-zone trust
   • Cset security zones security-zone trust
   • Dset security-zone trust
   Reveal Solution Discussion Select an answer first
2. 2foundation · easy

   Which method is used for initial access to an SRX Series device when it has no IP address configured?

   • AConsole connection via the serial port
   • BSSH over the management interface
   • CWeb interface over the management port
   • DTelnet over the ge-0/0/0 interface
   Reveal Solution Discussion Select an answer first
4. 3foundation · easy

   What is the default state of interfaces on an SRX Series device?

   • AAll interfaces are enabled by default.
   • BOnly management interfaces are enabled by default.
   • CInterfaces are enabled only after a reboot.
   • DInterfaces are disabled by default and must be explicitly enabled.
   Reveal Solution Discussion Select an answer first
5. 4application · easy

   An administrator has made several changes to an SRX configuration, including a new hostname and interface IP addresses. Before committing, the administrator wants to review the changes that have been made so far. Which command displays the uncommitted changes?

   • A`show system uptime`
   • B`show configuration`
   • C`show | compare`
   • D`show interfaces terse`
   Reveal Solution Discussion Select an answer first
6. 5foundation · easy

   What is the default security policy behavior on a factory-default SRX Series device?

   • AAll traffic is permitted between all zones.
   • BAll traffic is denied by default.
   • CTraffic from the trust zone to the untrust zone is permitted.
   • DTraffic is permitted only between interfaces in the same zone.
   Reveal Solution Discussion Select an answer first