Show Remote Connectivity to the BIG-IP Management Interface F5CAB4 Practice Questions (Page 4)

Questions 16–20

1. 16application · medium

   A network administrator needs to perform initial configuration on a new BIG-IP device. The device is racked and cabled, but no network configuration has been applied yet. The administrator is physically at the device. Which method should be used to access the Management interface for the first time?

   • AConnect to the console port using a standard Ethernet cable
   • BSerial console connection using a null-modem cable
   • CSSH to the default management IP address 192.168.1.245
   • DHTTPS to the default management IP address 192.168.1.245
   Reveal Solution Discussion Select an answer first
2. 17foundation · easy

   Which method verifies that the BIG-IP Configuration Utility is accessible via the Management interface?

   • AUsing SSH to connect to the management IP
   • BPinging the management IP
   • COpening a web browser to https://<management-ip>
   • DUsing SNMP to query the management IP
   Reveal Solution Discussion Select an answer first
4. 18foundation · easy

   Which of the following are common remote connectivity methods to the BIG-IP Management interface?

   • ARDP, VNC, and NTP
   • BSSH, HTTPS, and serial console
   • CFTP, Telnet, and SNMP
   • DHTTP, TFTP, and ICMP
   Reveal Solution Discussion Select an answer first
5. 19expert · hard

   An administrator is troubleshooting a BIG-IP device that is unreachable via SSH and HTTPS from the corporate network. The administrator has console access and verifies that the management IP is correctly configured and the interface is up. The administrator can ping the management IP from the corporate network. What is the most likely cause of the SSH and HTTPS failure?

   • AThe workstation is on a different subnet
   • BThe management interface is down
   • CThe SSH and HTTPS services are not listening on the management interface
   • DThe management IP is not routable from the corporate network
   Reveal Solution Discussion Select an answer first
6. 20application · medium

   An administrator is verifying remote connectivity to a BIG-IP Management interface. They can ping the management IP but cannot SSH. What should the administrator check next?

   • AThe management IP is correct
   • BThe management interface is up
   • CThe SSH service is enabled and listening on the management interface
   • DThe workstation has a route to the management network
   Reveal Solution Discussion Select an answer first