Show Remote Connectivity to the BIG-IP Management Interface F5CAB4 Practice Questions (Page 2)

Questions 6–10

1. 6application · medium

   An administrator is unable to access the BIG-IP Configuration utility via HTTPS. They have console access and run 'ip addr show mgmt' which shows the management IP as 10.10.10.5/24. They then try to ping 10.10.10.5 from their workstation and it fails. What is the most likely cause?

   • AThe management IP is incorrect
   • BThe HTTPS service is not listening
   • CThe workstation is not on the same subnet as the management IP
   • DThe management interface is down
   Reveal Solution Discussion Select an answer first
2. 7foundation · easy

   What is the primary purpose of the BIG-IP Management interface?

   • ATo provide administrative access to the BIG-IP system
   • BTo synchronize configuration with a peer BIG-IP device
   • CTo forward application traffic between clients and servers
   • DTo connect to a RADIUS server for authentication
   Reveal Solution Discussion Select an answer first
4. 8application · medium

   A BIG-IP device is deployed in a DMZ. The management network is separate from the DMZ network. An administrator needs to perform initial configuration and does not have network access to the management network yet. Which method should be used?

   • AUse the data-plane interface to access the management interface
   • BHTTPS to the management IP from the DMZ network
   • CSerial console connection
   • DSSH to the management IP from the DMZ network
   Reveal Solution Discussion Select an answer first
5. 9application · medium

   An administrator needs to verify that the management IP address on a BIG-IP device is reachable from the corporate network. Which command should be run from a workstation on the corporate network?

   • Atmsh list sys management-ip
   • Bping <management-ip>
   • Cip addr show mgmt
   • Dssh <management-ip>
   Reveal Solution Discussion Select an answer first
6. 10foundation · easy

   Which statement best describes the BIG-IP Management interface?

   • AIt is a dedicated interface used for administrative access and is separate from data-plane traffic.
   • BIt is the same as the external VLAN interface used for client traffic.
   • CIt is only accessible from the local console and cannot be configured with an IP address.
   • DIt is used for high-availability failover traffic between BIG-IP devices.
   Reveal Solution Discussion Select an answer first