Report Errors Which Occur During Config Sync F5CAB4 Practice Questions (Page 4)

Questions 16–20

1. 16foundation · easy

   An administrator sees the following message in the BIG-IP Configuration Utility: 'Config sync error: Unable to connect to peer device 192.168.1.2.' What is the most likely cause of this sync failure?

   • AThe device trust is not established
   • BThe software versions are incompatible
   • CThe peer device is unreachable or the sync port is blocked
   • DThe configuration files are out of sync
   Reveal Solution Discussion Select an answer first
2. 17expert · hard

   A BIG-IP device group has two devices. Config sync fails with the error: 'Config sync failed: Version mismatch.' The administrator checks the version and both devices show the same version and hotfix. What is the most likely cause?

   • AThe build numbers differ between the devices.
   • BThe configuration checksum is invalid.
   • CThe device trust has expired.
   • DThe network path is experiencing packet loss.
   Reveal Solution Discussion Select an answer first
4. 18expert · hard

   An administrator is troubleshooting a config sync failure. The error message is: 'Config sync failed: Unable to load configuration on peer.' The administrator has verified network connectivity, device trust, and version compatibility. What should the administrator do next?

   • ACheck the peer device's disk space and file system integrity.
   • BReboot the peer device.
   • CReport the error to F5 support without further investigation.
   • DRe-run the config sync manually.
   Reveal Solution Discussion Select an answer first
5. 19application · medium

   An administrator needs to report a config sync error to the change management board. The error is: 'Config sync failed: Syntax error in /config/bigip.conf.' Which additional detail would make the report most useful?

   • AThe last successful sync time.
   • BThe names of all administrators with access.
   • CThe serial numbers of the devices.
   • DThe line number and snippet of the configuration file where the error occurred.
   Reveal Solution Discussion Select an answer first
6. 20application · medium

   A BIG-IP device group is failing to sync. The error log shows: 'Config sync failed: Peer device is not in a valid state.' Both devices are up and can communicate. What should the administrator check first?

   • AThe network connectivity between the devices.
   • BThe configuration checksum on both devices.
   • CThe device trust status in the Device Management screens.
   • DThe BIG-IP version on both devices.
   Reveal Solution Discussion Select an answer first