
F5Certified Administrator, BIG-IP
Domain 8Objective 2
Report Errors Which Occur During Config Sync F5CAB4 Practice Questions (Page 2)
Part of the Explain config sync domain, which makes up ~14% of our current practice bank. F5 does not publish an official question count, but from its 30-minute exam (~10–20 total, ~1–3 in this domain), expect 1–1 from this objective — we provide 22 practice questions to prepare you well beyond it. (estimate)
22questions here
5free pages
4concepts
Questions 6–10
- 6
An administrator needs to report a config sync error to the network operations team. What is the BEST way to communicate the error?
Select an answer first - 7
While troubleshooting a config sync failure, an administrator runs the command `tmsh show cm sync-status` and sees the output: 'Status: In Sync'. What does this indicate?
Select an answer first - 8
A BIG-IP device in a sync-failover device group shows a config sync error. The error message states: 'Configuration on peer device does not match. Checksum mismatch.' The two devices are in the same data center, can ping each other, and both run the same BIG-IP version. What is the most likely cause of this error?
Select an answer first - 9
A BIG-IP device group has two devices, both running the same version and hotfix. Config sync fails with a checksum mismatch error. The administrator verifies that no local changes were made on either device. What is the most likely cause?
Select an answer first - 10
During a config sync attempt, the BIG-IP device reports that the peer device is running a different version of the BIG-IP software. Which type of config sync error is this?
Select an answer first
Finished these 5 questions?
Review the revealed explanations, or continue through the curriculum.
Free Basic Practice is a study aid with revealable answers — not a scored exam. Examers.io is independent and not affiliated with or endorsed by F5. “F5CAB4” is a trademark of its owner, used for identification only.