During physical verification of a VxRail cluster, the technician notices that one node's power LED is amber. What does this indicate?

The node is receiving power but is not fully booted.

The node is in standby mode and is functioning normally.

The node has a hardware fault and needs attention.

The node is in a low-power state and will boot automatically.

Which of the following is a valid physical verification step for VxRail switches?

Verify that the switch firmware is the latest version

Check that all switch ports have the correct link LEDs illuminated

Ensure that the switch is assigned to the correct rack unit

Confirm that the switch has a valid IP address

Before initializing a VxRail cluster, what physical check should be performed on the nodes?

Confirm that the vCenter server is licensed

Ensure the node's BIOS is updated to the latest version

Verify that all power and network cables are securely connected

Verify that the cluster name is unique in the environment

Before initializing a VxRail cluster, the technician performs a physical verification. Which check is part of this verification?

Check that the rack is grounded and the PDUs are connected to a UPS.

Confirm that all nodes are connected to the correct switch ports as documented.

Ensure that the cluster has internet access for licensing.

Verify that the vCenter Server is installed and running.

What is the purpose of configuring link aggregation (LACP) on VxRail top-of-rack switches?

To increase bandwidth and provide redundancy between the node and the switch

To enable remote management of the switch

To provide power over Ethernet to the nodes

To segment different types of network traffic

Dell VxRail Deploy v2

Domain 4Objective 2

Installing and Cabling VxRail Cluster Hardware VXRAIL-DEPLOY-V2 Practice Questions (Page 2)

Part of the VxRail Hardware Installation and Initialization domain, which accounts for 8% of the VXRAIL-DEPLOY-V2 exam.

19questions here

4free pages

4concepts

8%of the exam

Questions 6–10

6application · medium
During physical verification of a VxRail cluster, the technician notices that one node's power LED is amber. What does this indicate?
Select an answer first
7foundation · easy
Which of the following is a valid physical verification step for VxRail switches?
Select an answer first
8foundation · easy
Before initializing a VxRail cluster, what physical check should be performed on the nodes?
Select an answer first
9application · medium
Before initializing a VxRail cluster, the technician performs a physical verification. Which check is part of this verification?
Select an answer first
10foundation · easy
What is the purpose of configuring link aggregation (LACP) on VxRail top-of-rack switches?
Select an answer first

Finished these 5 questions?

Review the revealed explanations, or continue through the curriculum.

Next 5 questions →Back to VXRAIL-DEPLOY-V2

Free Basic Practice is a study aid with revealable answers — not a scored exam. Examers.io is independent and not affiliated with or endorsed by Dell Technologies. “VXRAIL-DEPLOY-V2” is a trademark of its owner, used for identification only.