A technician is cabling a VxRail node and needs to connect the network cables. The node has two 25GbE ports labeled 'vmnic0' and 'vmnic1'. According to the deployment guide, which ports should be used for the data network?

Use both vmnic0 and vmnic1 for the data network, connecting each to a different switch.

Use vmnic0 for the management network and vmnic1 for the data network.

Use vmnic0 for the data network and leave vmnic1 unconnected for future use.

Use vmnic0 and vmnic1 for the data network, but connect both to the same switch.

A VxRail cluster is being deployed with two top-of-rack switches. The switches are configured with a virtual link trunking (VLT) or similar stacking technology. What is the purpose of this configuration?

To increase the number of available ports on each switch.

To allow the switches to share a single power supply.

To allow both switches to act as a single logical switch for the cluster.

To enable the switches to be managed from a single IP address.

Which configuration is typically required for VxRail top-of-rack switches?

Spanning Tree Protocol disabled on all ports

Jumbo frames enabled only on management VLAN

VLANs for management, vSAN, and VM traffic

According to the VxRail deployment guide, which cable type is used to connect the VxRail node's network ports to the top-of-rack switches?

Ethernet cables (copper or fiber) depending on the switch port type

A technician is cabling a VxRail node and needs to connect the power cables. The node has two power supplies. What is the recommended practice for connecting power?

Connect both power supplies to the same PDU but use different outlets.

Connect both power supplies to the same PDU to simplify cable management.

Connect only one power supply and leave the other unconnected to save power.

Connect each power supply to a different PDU to provide redundancy.

Dell VxRail Deploy v2

Domain 4Objective 2

Installing and Cabling VxRail Cluster Hardware VXRAIL-DEPLOY-V2 Practice Questions (Page 1)

Part of the VxRail Hardware Installation and Initialization domain, which accounts for 8% of the VXRAIL-DEPLOY-V2 exam.

19questions here

4free pages

4concepts

8%of the exam

Questions 1–5

1application · medium
A technician is cabling a VxRail node and needs to connect the network cables. The node has two 25GbE ports labeled 'vmnic0' and 'vmnic1'. According to the deployment guide, which ports should be used for the data network?
Select an answer first
2application · medium
A VxRail cluster is being deployed with two top-of-rack switches. The switches are configured with a virtual link trunking (VLT) or similar stacking technology. What is the purpose of this configuration?
Select an answer first
3foundation · easy
Which configuration is typically required for VxRail top-of-rack switches?
Select an answer first
4foundation · easy
According to the VxRail deployment guide, which cable type is used to connect the VxRail node's network ports to the top-of-rack switches?
Select an answer first
5application · medium
A technician is cabling a VxRail node and needs to connect the power cables. The node has two power supplies. What is the recommended practice for connecting power?
Select an answer first

Finished these 5 questions?

Review the revealed explanations, or continue through the curriculum.

Next 5 questions →Back to VXRAIL-DEPLOY-V2

Free Basic Practice is a study aid with revealable answers — not a scored exam. Examers.io is independent and not affiliated with or endorsed by Dell Technologies. “VXRAIL-DEPLOY-V2” is a trademark of its owner, used for identification only.