Configure Ad Verify BGP EVPN with Symmetric IRB SONIC-DEPLOY Practice Questions (Page 2)

Questions 6–10

1. 6foundation · easy

   What is the purpose of configuring a BGP peer group for EVPN on a Dell SONiC switch?

   • ATo restrict EVPN routes to a single VNI
   • BTo enable BGP fast convergence for EVPN routes
   • CTo apply common EVPN settings to multiple BGP peers
   • DTo automatically establish VXLAN tunnels between peers
   Reveal Solution Discussion Select an answer first
2. 7application · medium

   A network engineer is configuring BGP EVPN on a Dell SONiC leaf switch. The engineer has configured the L2 VNI (VNI 10010) for VLAN 100 and the L3 VNI (VNI 10020) for the VRF. The engineer needs to ensure that MAC routes for VLAN 100 are advertised to remote VTEPs, but IP routes for the VRF are advertised with a different route target. What is the correct configuration?

   • AConfigure the route target only on the L3 VNI and not on the L2 VNI.
   • BConfigure the route target only on the L2 VNI and not on the L3 VNI.
   • CConfigure a unique route target for the L2 VNI and a different unique route target for the L3 VNI.
   • DConfigure the same route target for both the L2 VNI and the L3 VNI.
   Reveal Solution Discussion Select an answer first
4. 8foundation · easy

   In a symmetric IRB design, what is the purpose of using a consistent anycast gateway MAC and IP address across all VTEPs?

   • ATo reduce the number of VNIs required in the fabric
   • BTo enable seamless host mobility and active-active gateway redundancy
   • CTo eliminate the need for VXLAN tunnels between VTEPs
   • DTo simplify BGP EVPN route target configuration
   Reveal Solution Discussion Select an answer first
5. 9application · medium

   A network engineer is verifying the BGP EVPN configuration on a Dell SONiC leaf switch. The engineer wants to confirm that the leaf has received the correct EVPN routes from its iBGP peer and that the routes are being imported into the correct VNI. Which command should the engineer use to see the detailed EVPN routes, including the route targets and the VNI they are associated with?

   • Ashow mac address-table
   • Bshow bgp l2vpn evpn
   • Cshow evpn vni
   • Dshow vxlan tunnel
   Reveal Solution Discussion Select an answer first
6. 10foundation · easy

   What is the function of a route target in BGP EVPN?

   • ATo define the anycast gateway MAC address
   • BTo set the BGP next-hop for EVPN routes
   • CTo control which VNIs are imported and exported by a VTEP
   • DTo specify the VXLAN tunnel source IP address
   Reveal Solution Discussion Select an answer first