Describe the Components of OSPF POWERSWITCH-DATA-CENTER-DEPLOY Practice Questions (Page 2)

Questions 6–10

1. 6foundation · easy

   What is the default OSPF cost of a 1 Gbps interface when the reference bandwidth is 100 Mbps?

   • A1
   • B0
   • C10
   • D100
   Reveal Solution Discussion Select an answer first
2. 7foundation · easy

   Which statement correctly describes the OSPF router ID?

   • AIt is the MAC address of the router's management interface.
   • BIt is automatically changed whenever a new interface is added.
   • CIt is a 32-bit value that uniquely identifies a router in the OSPF domain.
   • DIt is always the highest IP address on the router.
   Reveal Solution Discussion Select an answer first
4. 8foundation · easy

   Which OSPF area type is used to connect all other areas and must be present in every OSPF network?

   • ANSSA
   • BStub area
   • CBackbone area
   • DTotally stubby area
   Reveal Solution Discussion Select an answer first
5. 9application · medium

   Two OSPF routers on a broadcast segment are stuck in the ExStart state. The routers have matching OSPF area IDs, timers, and authentication. What is the most likely cause of this issue?

   • AThe routers have different OSPF network types.
   • BThe routers have different OSPF router IDs.
   • CThe routers have different OSPF dead intervals.
   • DThe routers have mismatched MTU sizes on the interface.
   Reveal Solution Discussion Select an answer first
6. 10foundation · easy

   How does OSPF calculate the cost of an interface by default?

   • ABy adding the interface bandwidth to a fixed value
   • BBy using the interface delay as the cost
   • CBy multiplying the interface bandwidth by a constant
   • DBy dividing the reference bandwidth by the interface bandwidth
   Reveal Solution Discussion Select an answer first