Configure and Verify the Operation of PBR POWERSWITCH-DATA-CENTER-DEPLOY Practice Questions (Page 1)

Questions 1–5

1. 1foundation · easy

   Which two components are required to configure Policy-Based Routing (PBR) on a Dell PowerSwitch device?

   • AA VLAN and a trunk port
   • BA routing protocol and a static route
   • CA route map and an access list
   • DA loopback interface and a default gateway
   Reveal Solution Discussion Select an answer first
2. 2foundation · easy

   A network engineer wants to see detailed information about packets that are being processed by a PBR route map, including whether they matched and what action was taken. Which type of command would provide this information?

   • Ashow ip interface
   • Bshow ip policy
   • Cshow ip route
   • Ddebug ip policy
   Reveal Solution Discussion Select an answer first
4. 3application · medium

   A network administrator is configuring PBR on a Dell PowerSwitch to route traffic from the 192.168.100.0/24 subnet to a next-hop of 10.10.10.1. The route map 'PBR-TEST' has been created with a match clause for an access list that matches the subnet. What is the correct set command to include in the route map to direct traffic to the next-hop?

   • Aset ip next-hop 10.10.10.1
   • Bset ip route 10.10.10.1
   • Cset ip default next-hop 10.10.10.1
   • Dset next-hop 10.10.10.1
   Reveal Solution Discussion Select an answer first
5. 4foundation · easy

   In a data center network, what is the primary purpose of Policy-Based Routing (PBR)?

   • ATo forward packets based on criteria other than the destination IP address, such as source IP, protocol, or packet size
   • BTo provide redundancy by automatically failing over to a backup link when the primary link goes down
   • CTo automatically load-balance traffic across all available equal-cost paths
   • DTo replace the routing table with a set of static routes for all traffic
   Reveal Solution Discussion Select an answer first
6. 5application · medium

   A data center has a Dell PowerSwitch that connects to two different service providers. The network team wants to send all traffic from the 10.100.0.0/16 subnet to Service Provider A, while all other traffic uses Service Provider B. What is the primary benefit of using PBR instead of static routes for this requirement?

   • APBR automatically load-balances traffic across multiple paths.
   • BPBR allows routing decisions based on source IP address, not just destination.
   • CPBR provides faster convergence than static routes.
   • DPBR eliminates the need for access control lists.
   Reveal Solution Discussion Select an answer first