Configure and Verify the Operation of PBR POWERSWITCH-DATA-CENTER-DEPLOY Practice Questions (Page 2)

Questions 6–10

1. 6application · medium

   An administrator has configured PBR on a Dell PowerSwitch to send traffic from the 192.168.50.0/24 network to a next-hop of 10.0.0.2. After applying the policy, traffic from that subnet is still being forwarded via the default route. Which show command should be used to verify that the route map is correctly matching the traffic?

   • Ashow ip policy
   • Bshow route-map
   • Cshow ip policy statistics
   • Dshow ip policy route-map
   Reveal Solution Discussion Select an answer first
2. 7foundation · easy

   Which command would you use on a Dell PowerSwitch to verify that a route map has been applied to an interface for PBR?

   • Ashow running-config interface
   • Bshow access-lists
   • Cshow ip route
   • Dshow ip policy
   Reveal Solution Discussion Select an answer first
4. 8foundation · easy

   A network engineer wants to send all traffic from a specific application server to a dedicated security appliance for inspection, while all other traffic uses the normal routing table. Which feature is designed to accomplish this?

   • AVirtual LAN (VLAN) segmentation
   • BPolicy-Based Routing (PBR)
   • CDynamic Host Configuration Protocol (DHCP)
   • DAccess Control Lists (ACLs) applied to interfaces for filtering
   Reveal Solution Discussion Select an answer first
5. 9foundation · easy

   In a PBR configuration on a Dell PowerSwitch, what is the purpose of the 'set ip next-hop' command within a route map?

   • ATo define the source IP address of the traffic that will be matched
   • BTo specify the next-hop IP address to which matched traffic should be forwarded
   • CTo define the destination IP address of the traffic that will be matched
   • DTo enable the route map on a specific interface
   Reveal Solution Discussion Select an answer first
6. 10foundation · easy

   A PBR route map is configured to send traffic from a specific source to a next-hop of 10.0.0.1. However, traffic is still being forwarded via the routing table. Which of the following is a likely cause?

   • AThe route map is applied to the correct inbound interface
   • BThe access list is matching the correct source IP
   • CThe route map sequence number is set to 10
   • DThe next-hop 10.0.0.1 is not reachable
   Reveal Solution Discussion Select an answer first