Configure and Verify the Operation of PBR POWERSWITCH-DATA-CENTER-DEPLOY Practice Questions (Page 3)

Questions 11–12

1. 11foundation · easy

   When troubleshooting PBR, which issue is most likely to cause traffic to be forwarded using the normal routing table instead of the policy?

   • AThe next-hop IP address is reachable and valid
   • BThe route map has a higher sequence number than another route map
   • CThe route map is applied to the outbound interface instead of the inbound interface
   • DThe access list used for matching is too permissive
   Reveal Solution Discussion Select an answer first
2. 12expert · hard

   A Dell PowerSwitch is configured with PBR to route traffic from the 10.1.1.0/24 subnet to a next-hop of 192.168.1.1. The route map is applied to the correct interface, and the access list matches the source subnet. However, traffic from the subnet is still being forwarded via the routing table. The engineer runs 'show ip policy statistics' and sees that the match counter is NOT incrementing. What is the most likely cause of this issue?

   • AThe route map is missing a 'set ip next-hop' command.
   • BThe route map is applied to the egress interface.
   • CThe access list is not matching the traffic.
   • DThe next-hop is not reachable.
   Reveal Solution Discussion Select an answer first