An administrator wants to advertise a summary route 10.0.0.0/8 into BGP on a Dell PowerSwitch. The switch has more specific routes (10.1.0.0/16, 10.2.0.0/16, etc.) in the routing table. The administrator enters 'network 10.0.0.0 mask 255.0.0.0' under BGP. The route does not appear in the BGP table. What is the most likely cause?

The BGP session is not established.

The more specific routes are not in the BGP table.

The summary route needs to be redistributed.

The network command requires an exact match in the routing table.

What is the key difference between eBGP and iBGP?

eBGP uses TCP port 179, while iBGP uses TCP port 1790.

eBGP operates between different autonomous systems, while iBGP operates within the same autonomous system.

eBGP requires a full mesh of sessions, while iBGP does not require a full mesh.

eBGP operates within a single autonomous system, while iBGP operates between different autonomous systems.

An engineer needs to verify that a Dell PowerSwitch is receiving a specific prefix from an eBGP neighbor. Which command should be used to check the BGP table for this prefix?

show ip bgp neighbors advertised-routes

Dell PowerSwitch Data Center Deploy

Domain 4Objective 5

Configure and Verify the Operation of BGP POWERSWITCH-DATA-CENTER-DEPLOY Practice Questions (Page 3)

Part of the IP Routing domain, which accounts for 20% of the POWERSWITCH-DATA-CENTER-DEPLOY exam.

21questions here

5free pages

7concepts

20%of the exam

Questions 11–15

11expert · hard
An administrator wants to advertise a summary route 10.0.0.0/8 into BGP on a Dell PowerSwitch. The switch has more specific routes (10.1.0.0/16, 10.2.0.0/16, etc.) in the routing table. The administrator enters 'network 10.0.0.0 mask 255.0.0.0' under BGP. The route does not appear in the BGP table. What is the most likely cause?
Select an answer first
12application · medium
A network administrator wants to prefer a specific BGP route from a neighbor for traffic leaving the local AS. The route is received from an eBGP peer. Which attribute should be manipulated on the inbound route to influence outbound traffic?
Select an answer first
13foundation · easy
What is the key difference between eBGP and iBGP?
Select an answer first
14foundation · easy
Which BGP attribute is the first criterion used in the BGP path selection process?
Select an answer first
15application · easy
An engineer needs to verify that a Dell PowerSwitch is receiving a specific prefix from an eBGP neighbor. Which command should be used to check the BGP table for this prefix?
Select an answer first

Finished these 5 questions?

Review the revealed explanations, or continue through the curriculum.

Next 5 questions →Back to POWERSWITCH-DATA-CENTER-DEPLOY

Free Basic Practice is a study aid with revealable answers — not a scored exam. Examers.io is independent and not affiliated with or endorsed by Dell Technologies. “POWERSWITCH-DATA-CENTER-DEPLOY” is a trademark of its owner, used for identification only.

Configure and Verify the Operation of BGP POWERSWITCH-DATA-CENTER-DEPLOY Practice Questions (Page 3)

Questions 11–15

A network administrator wants to prefer a specific BGP route from a neighbor for traffic leaving the local AS. The route is received from an eBGP peer. Which attribute should be manipulated on the inbound route to influence outbound traffic?

What is the key difference between eBGP and iBGP?

Which BGP attribute is the first criterion used in the BGP path selection process?

An engineer needs to verify that a Dell PowerSwitch is receiving a specific prefix from an eBGP neighbor. Which command should be used to check the BGP table for this prefix?

Keep studying — IP Routing