Dell PowerSwitch Data Center Deploy
Domain 4Objective 5
Configure and Verify the Operation of BGP POWERSWITCH-DATA-CENTER-DEPLOY Practice Questions (Page 2)
Part of the IP Routing domain, which accounts for 20% of the POWERSWITCH-DATA-CENTER-DEPLOY exam.
21questions here
5free pages
7concepts
20%of the exam
Questions 6–10
- 6
Which BGP session state indicates that the router has received a valid BGP OPEN message and is waiting for a KEEPALIVE message?
Select an answer first - 7
A data center has two iBGP speakers, R1 and R2, in the same AS. R1 learns a route from an eBGP peer and advertises it to R2. R2 installs the route in its BGP table but does not use it for forwarding. The next hop advertised by R1 is the eBGP peer's address, which is not directly connected to R2. What is the most likely reason the route is not used?
Select an answer first - 8
A network engineer is configuring BGP between two Dell PowerSwitch data center switches in different ASes. The neighbor relationship remains in the Active state. The engineer confirms that the neighbor IP address is correct, the remote AS number is correct, and both switches have reachable loopback interfaces. Which additional configuration is most likely required to establish the session?
Select an answer first - 9
Which BGP attribute can be manipulated using a route map to influence inbound traffic by setting a lower value to make a path more preferred?
Select an answer first - 10
Which command is used to advertise a network into BGP on a Dell PowerSwitch?
Select an answer first
Finished these 5 questions?
Review the revealed explanations, or continue through the curriculum.
Free Basic Practice is a study aid with revealable answers — not a scored exam. Examers.io is independent and not affiliated with or endorsed by Dell Technologies. “POWERSWITCH-DATA-CENTER-DEPLOY” is a trademark of its owner, used for identification only.