Dell PowerSwitch Data Center Deploy
Domain 4Objective 3
Configure and Verify a Single Area of OSPF Topology POWERSWITCH-DATA-CENTER-DEPLOY Practice Questions (Page 2)
Part of the IP Routing domain, which accounts for 20% of the POWERSWITCH-DATA-CENTER-DEPLOY exam.
19questions here
4free pages
4concepts
20%of the exam
Questions 6–10
- 6
Two Dell PowerSwitch switches are connected via a Layer 2 trunk. OSPF is configured on both, but the adjacency is not forming. You check 'show ip ospf interface' and see that the interface is in DOWN state. What is the most likely cause?
Select an answer first - 7
A Dell PowerSwitch S5232F-ON has an OSPF adjacency that is flapping. 'show ip ospf neighbor' shows the state going from FULL to DOWN repeatedly. You check 'show ip ospf interface' and see that the dead interval is 40 seconds and the hello interval is 10 seconds. What is the most likely cause of the flapping?
Select an answer first - 8
Which show command on a Dell PowerSwitch displays the current OSPF neighbor adjacencies and their states?
Select an answer first - 9
A Dell PowerSwitch S4048-ON is connected to a third-party switch. OSPF adjacency is stuck in EXSTART state. You verify that both sides have the same area ID, timers, and network type. What is the most likely remaining cause?
Select an answer first - 10
In a single-area OSPF network with three Dell PowerSwitch switches, you need to determine which switch is the designated router (DR) on a broadcast segment. Which command provides this information?
Select an answer first
Finished these 5 questions?
Review the revealed explanations, or continue through the curriculum.
Free Basic Practice is a study aid with revealable answers — not a scored exam. Examers.io is independent and not affiliated with or endorsed by Dell Technologies. “POWERSWITCH-DATA-CENTER-DEPLOY” is a trademark of its owner, used for identification only.