Identify the Components and Use Cases for Stacking POWERSWITCH-CAMPUS-DEPLOY Practice Questions (Page 3)

Questions 11–15

1. 11foundation · easy

   Which scenario best illustrates a primary benefit of stacking Dell PowerSwitch switches?

   • AA data center requires high-performance computing with low-latency interconnects
   • BA branch office needs to connect to the internet with a redundant WAN link
   • CA campus network needs to add more switch ports without creating additional management points
   • DA small office needs to segment traffic between different departments
   Reveal Solution Discussion Select an answer first
2. 12foundation · easy

   What is the purpose of a stacking module in a Dell PowerSwitch stack?

   • AIt supplies redundant power to the stack members
   • BIt converts copper ports to fiber for uplink connections
   • CIt manages the stack's configuration and firmware
   • DIt provides the high-speed interface used to connect stack members
   Reveal Solution Discussion Select an answer first
4. 13application · medium

   A school district is standardizing on Dell PowerSwitch switches. They have a mix of S-series and N-series switches. The network architect wants to stack switches in a new building. What should the architect verify first?

   • AThat all switches have the same firmware version.
   • BThat all switches have the same number of ports.
   • CThat all switches are from the same manufacturing batch.
   • DThat all switches in the stack are the same model and series.
   Reveal Solution Discussion Select an answer first
5. 14expert · hard

   A company has a legacy network with 20 standalone Dell PowerSwitch switches. They want to migrate to a stacked architecture to reduce management overhead. The budget is limited, and they cannot replace all switches. What is the most cost-effective approach?

   • AReplace all switches with new stackable models.
   • BStack all switches regardless of model and location.
   • CUse VLT to connect all switches.
   • DStack switches that are in the same wiring closet and are model-compatible.
   Reveal Solution Discussion Select an answer first
6. 15application · medium

   A network admin is adding a new switch to an existing Dell PowerSwitch stack. The admin has the correct stacking module and cable. What must the admin do before physically connecting the new switch to the stack?

   • AConnect the stacking cable while the new switch is powered on.
   • BConfigure the new switch's hostname before connecting.
   • CPower off the new switch before connecting the stacking cable.
   • DAssign a static IP address to the new switch before connecting.
   Reveal Solution Discussion Select an answer first