Configure and Verify IPv6 Address Assignment D-PCM-DY-23 POWERSWITCH-CAMPUS-DEPLOY Practice Questions (Page 2)

Questions 6–10

1. 6foundation · easy

   After configuring a static IPv6 address on a Dell PowerSwitch interface, which command verifies that the address is correctly assigned and the interface is up?

   • Ashow running-config interface
   • Bshow ipv6 interface brief
   • Cshow ip interface brief
   • Dshow arp
   Reveal Solution Discussion Select an answer first
2. 7application · medium

   A network administrator has configured SLAAC on a Dell PowerSwitch S5232F-ON for a VLAN. After connecting test hosts, the administrator notices that the hosts are not receiving IPv6 addresses. Which command should be used to verify that the switch is sending Router Advertisements?

   • A`show ipv6 interface`
   • B`show ipv6 nd ra-interval`
   • C`show ipv6 route`
   • D`show ipv6 neighbors`
   Reveal Solution Discussion Select an answer first
4. 8foundation · easy

   Which show command displays the IPv6 addresses assigned to all interfaces on a Dell PowerSwitch?

   • Ashow ipv6 route
   • Bshow ip interface brief
   • Cshow running-config
   • Dshow ipv6 interface brief
   Reveal Solution Discussion Select an answer first
5. 9application · medium

   A managed service provider runs a Dell PowerSwitch S4148T-ON as a CPE device for a customer. The customer requires that all devices on the LAN receive IPv6 addresses from a central DHCPv6 server located at the provider's head office, not from the CPE switch. The CPE switch must relay DHCPv6 requests from the LAN to the head-office server. Which configuration is required on the switch?

   • AConfigure `ipv6 dhcp server` on the VLAN interface with a local pool.
   • BConfigure `ipv6 nd managed-config-flag` on the VLAN interface.
   • CConfigure `ipv6 address dhcp` on the VLAN interface.
   • DConfigure `ipv6 dhcp relay` on the VLAN interface with the head-office server's address.
   Reveal Solution Discussion Select an answer first
6. 10application · medium

   A university IT team manages a Dell PowerSwitch N3048P that serves as the default gateway for a dormitory network. The university requires that every student device receive a unique, centrally tracked IPv6 address so that network usage can be attributed to individual students for policy enforcement. The team wants to use DHCPv6 for stateful address assignment. Which configuration must be applied on the switch's VLAN interface?

   • AConfigure a static IPv6 address on the interface and enable `ipv6 dhcp server` with a pool that includes the same subnet.
   • BConfigure `ipv6 nd managed-config-flag` on the interface without a DHCPv6 server.
   • CConfigure `ipv6 nd other-config-flag` on the interface and rely on SLAAC for addresses.
   • DConfigure `ipv6 address dhcp` on the interface and enable `ipv6 dhcp server` globally.
   Reveal Solution Discussion Select an answer first