Dell PowerSwitch Campus Deploy
Domain 6Objective 6
Configure and Verify Differentiated Services Code Points DSCP and 802.1p (CoS) POWERSWITCH-CAMPUS-DEPLOY Practice Questions (Page 4)
Part of the Campus Services domain, which accounts for 20% of the POWERSWITCH-CAMPUS-DEPLOY exam.
19questions here
4free pages
6concepts
20%of the exam
Questions 16–19
- 16
Which command would you use to verify the QoS trust mode configured on a specific interface?
Select an answer first - 17
A network engineer is troubleshooting QoS on a Dell PowerSwitch. Traffic from a server is marked with DSCP AF31 (26). The switch port is configured to trust DSCP. The engineer wants to verify that the DSCP marking is being honored. Which command should be used to check the DSCP trust state on the port?
Select an answer first - 18
After configuring DSCP trust on a Dell PowerSwitch port, an engineer wants to verify that the port is actually trusting DSCP and not 802.1p. Which command should be used to confirm this?
Select an answer first - 19
Which command would you use on a Dell PowerSwitch to verify the DSCP-to-802.1p mapping table?
Select an answer first
Finished these 4 questions?
Review the revealed explanations, or continue through the curriculum.
No more pagesBack to POWERSWITCH-CAMPUS-DEPLOY
Free Basic Practice is a study aid with revealable answers — not a scored exam. Examers.io is independent and not affiliated with or endorsed by Dell Technologies. “POWERSWITCH-CAMPUS-DEPLOY” is a trademark of its owner, used for identification only.