Prepare a Node for Operation POWERSCALE-MAINTENANCE Practice Questions (Page 4)

Questions 16–19

1. 16foundation · easy

   What is the purpose of configuring the boot settings on a PowerScale node?

   • ATo enable hardware diagnostics on the node
   • BTo configure the node's power management settings
   • CTo ensure the node boots from the correct source to load OneFS
   • DTo set the node's hostname and IP address
   Reveal Solution Discussion Select an answer first
2. 17application · medium

   A technician is racking a new PowerScale node. After sliding the node into the rails and securing the bezel, the technician connects the two power supplies to separate PDUs and plugs in the cluster network cables. Before powering on the node, which action is most important to verify?

   • AThe node's bezel is locked to prevent accidental removal during operation.
   • BThe power cords are dressed neatly with velcro straps to the cable management arm.
   • CThe node's service tag matches the rack location documented in the deployment plan.
   • DThe InfiniBand or Ethernet cables are fully seated and the link LEDs on the node and the top-of-rack switch indicate a connection.
   Reveal Solution Discussion Select an answer first
4. 18application · medium

   After booting a new PowerScale node, an administrator wants to confirm the node is healthy before adding it to the cluster. Which command should be run on the node to check the status of its hardware components?

   • Aisi network status
   • Bisi status
   • Cisi hardware status
   • Disi drive status
   Reveal Solution Discussion Select an answer first
5. 19application · medium

   A technician is installing a new PowerScale node. After seating the node in the rack, the technician connects the power cables and network cables. Before powering on the node, which check is essential to ensure the node can communicate with the cluster?

   • ACheck that the node's power supplies are plugged into the same PDU.
   • BConfirm that the node's bezel is properly attached.
   • CVerify that the network cables are connected to the correct ports on the node and the switch.
   • DEnsure that the node's service tag is visible for identification.
   Reveal Solution Discussion Select an answer first