Demonstrate the Use of Simplified Symmwin to Perform an FRU Procedure POWERMAX-MAINTENANCE Practice Questions (Page 5)

Questions 21–25

1. 21foundation · medium

   After replacing an FRU, what should the technician check in Simplified Symmwin to confirm the new FRU is recognized?

   • AThe FRU is no longer listed in the system
   • BThe FRU is marked as 'Not Ready'
   • CThe status indicator for the FRU shows green
   • DThe FRU shows a red status indicator
   Reveal Solution Discussion Select an answer first
2. 22foundation · medium

   What is the final step in Simplified Symmwin to verify a successful FRU replacement?

   • AReboot the entire array
   • BConfirm the FRU is in a 'Ready' state and the procedure is complete
   • CRemove the FRU from the configuration
   • DRun a full system diagnostic
   Reveal Solution Discussion Select an answer first
4. 23application · medium

   In Simplified Symmwin, a technician is looking at the Hardware view and sees a component with a 'Not Present' status. What does this status indicate?

   • AThe component is not installed in the array.
   • BThe component is present but temporarily offline for maintenance.
   • CThe component is installed but not yet recognized by the system.
   • DThe component is present but has failed.
   Reveal Solution Discussion Select an answer first
5. 24expert · hard

   After replacing a faulty power supply, the administrator checks Simplified Symmwin and sees the power supply status is 'Online', but an alert is still present for the component. What should the administrator do?

   • AIgnore the alert because the status is 'Online'.
   • BReboot the array to clear the alert.
   • CReplace the power supply again because the alert indicates a problem.
   • DCheck the alert details to determine if it is a new alert or a stale alert from the previous failure.
   Reveal Solution Discussion Select an answer first
6. 25application · medium

   A technician is using Simplified Symmwin to replace a faulty fan module. The technician needs to find the specific FRU procedure for the fan module. Where in the Simplified Symmwin interface should the technician look?

   • AIn the Alerts view, click on the fan module alert and select 'Run Procedure'.
   • BIn the Service view, choose 'FRU Procedures' from the drop-down menu.
   • CIn the Hardware view, select the fan module and click 'Replace FRU'.
   • DIn the Inventory view, right-click the fan module and select 'Properties'.
   Reveal Solution Discussion Select an answer first