Dell PowerEdge XE Operate
Domain 1Objective 6
Verify Node Readiness Using iDRAC POWEREDGE-XE-OPERATE Practice Questions (Page 5)
Part of the Scaling Solutions domain, which accounts for 19% of the POWEREDGE-XE-OPERATE exam.
38questions here
8free pages
10concepts
19%of the exam
Questions 21–25
- 21
Which iDRAC page displays current readings for temperature, voltage, and fan sensors?
Select an answer first - 22
Which iDRAC page provides information about storage controllers and RAID configuration?
Select an answer first - 23
A technician is preparing a PowerEdge XE node for inclusion in a high-performance computing cluster. The node was just racked and powered on, but the technician cannot reach the iDRAC web interface from the management workstation. The technician confirms the management network cable is seated and the switch port shows link. Which step should the technician take FIRST to begin verifying node readiness?
Select an answer first - 24
A technician is performing initial node readiness verification on a PowerEdge XE server. The technician accesses iDRAC and sees the power state is 'Off' and the health status is 'OK'. What should the technician do to continue the readiness verification?
Select an answer first - 25
A PowerEdge XE node is being validated for a database cluster that requires a RAID 10 configuration for the boot volume. The administrator accesses iDRAC and navigates to the Storage page. The page shows the PERC controller is present and healthy, but the virtual disk is configured as RAID 5. What should the administrator do to prepare the node?
Select an answer first
Finished these 5 questions?
Review the revealed explanations, or continue through the curriculum.
Free Basic Practice is a study aid with revealable answers — not a scored exam. Examers.io is independent and not affiliated with or endorsed by Dell Technologies. “POWEREDGE-XE-OPERATE” is a trademark of its owner, used for identification only.