A PowerEdge XE node is being prepared for a cluster that requires a specific RAID configuration. The iDRAC Storage page shows the PERC controller is present, but the virtual disk status is 'Degraded'. The system event log shows a 'Physical disk failed' entry for disk 4. The administrator has a spare disk available. What should the administrator do to restore the node to readiness?

Replace the failed physical disk and rebuild the virtual disk to restore redundancy

Clear the system event log to remove the 'Physical disk failed' entry

Reconfigure the virtual disk to a different RAID level to avoid the failed disk

Proceed with deployment since the virtual disk is still accessible

A technician needs to begin verifying node readiness on a Dell PowerEdge server. Which two methods can be used to access the iDRAC management interface?

Connect a monitor and keyboard to the server's front panel

SSH to the host operating system and run the ipmitool command

Use the server's LCD panel to navigate the iDRAC menus

Open a web browser to the iDRAC IP address or use the RACADM command-line utility

Dell PowerEdge XE Operate

Domain 1Objective 6

Verify Node Readiness Using iDRAC POWEREDGE-XE-OPERATE Practice Questions (Page 4)

Part of the Scaling Solutions domain, which accounts for 19% of the POWEREDGE-XE-OPERATE exam.

38questions here

8free pages

10concepts

19%of the exam

10 Concepts in This Objective

iDRAC interface access
Power and health status check
Firmware and driver version verification
Hardware inventory validation
Sensor and thermal status review
Event log inspection
Storage and RAID configuration check
Network connectivity verification
Boot configuration and boot order validation
iDRAC license and feature validation

Questions 16–20

16expert · hard
A PowerEdge XE node is being prepared for a cluster that requires a specific RAID configuration. The iDRAC Storage page shows the PERC controller is present, but the virtual disk status is 'Degraded'. The system event log shows a 'Physical disk failed' entry for disk 4. The administrator has a spare disk available. What should the administrator do to restore the node to readiness?
Select an answer first
17foundation · easy
A technician needs to begin verifying node readiness on a Dell PowerEdge server. Which two methods can be used to access the iDRAC management interface?
Select an answer first
18foundation · easy
Which iDRAC page shows the list of installed hardware components such as CPU, memory, storage, and NICs?
Select an answer first
19foundation · easy
Which RACADM command is used to view the system event log?
Select an answer first
20foundation · easy
Where in the iDRAC web interface can you view the current iDRAC license type and features?
Select an answer first

Finished these 5 questions?

Review the revealed explanations, or continue through the curriculum.

Next 5 questions →Back to POWEREDGE-XE-OPERATE

Free Basic Practice is a study aid with revealable answers — not a scored exam. Examers.io is independent and not affiliated with or endorsed by Dell Technologies. “POWEREDGE-XE-OPERATE” is a trademark of its owner, used for identification only.

Verify Node Readiness Using iDRAC POWEREDGE-XE-OPERATE Practice Questions (Page 4)

Questions 16–20

A technician needs to begin verifying node readiness on a Dell PowerEdge server. Which two methods can be used to access the iDRAC management interface?

Which iDRAC page shows the list of installed hardware components such as CPU, memory, storage, and NICs?

Which RACADM command is used to view the system event log?

Where in the iDRAC web interface can you view the current iDRAC license type and features?

Keep studying — Scaling Solutions