Dell PowerEdge XE Operate
Domain 1Objective 6
Verify Node Readiness Using iDRAC POWEREDGE-XE-OPERATE Practice Questions (Page 3)
Part of the Scaling Solutions domain, which accounts for 19% of the POWEREDGE-XE-OPERATE exam.
38questions here
8free pages
10concepts
19%of the exam
Questions 11–15
- 11
An administrator is validating a PowerEdge XE node for a cluster that requires full remote management and monitoring capabilities. The administrator accesses iDRAC and notices that the 'Remote Console' and 'Virtual Media' features are not available in the interface. What should the administrator check to resolve this?
Select an answer first - 12
Where in the iDRAC web interface can you find the current firmware versions of components like BIOS, iDRAC, and storage controllers?
Select an answer first - 13
Which RACADM command is used to view the iDRAC license information?
Select an answer first - 14
A PowerEdge XE node is being prepared to boot from a local NVMe drive in UEFI mode. The administrator accesses iDRAC and confirms the boot mode is UEFI and the NVMe drive is listed in the boot order. However, the node fails to boot and the system event log shows 'No boot device found'. What should the administrator do?
Select an answer first - 15
A PowerEdge XE node reports a health status of 'Warning' in iDRAC. The sensor readings show the system board temperature is within range, but the fan speed is at 100% and the system event log contains a 'Fan redundancy lost' entry. The node is scheduled for production deployment in 2 hours. What should the administrator do?
Select an answer first
Finished these 5 questions?
Review the revealed explanations, or continue through the curriculum.
Free Basic Practice is a study aid with revealable answers — not a scored exam. Examers.io is independent and not affiliated with or endorsed by Dell Technologies. “POWEREDGE-XE-OPERATE” is a trademark of its owner, used for identification only.