After replacing a failed hard drive in a RAID array, what should you verify to confirm the system has fully recovered?

The new drive is visible in the RAID controller BIOS

The RAID array has completed a rebuild and the operating system boots normally

You have identified a faulty power supply unit (PSU) in a PowerEdge R740 with redundant PSUs. The server is running critical workloads. What is the correct procedure to replace the PSU safely?

Disconnect all power cables from the server before removing the PSU

Remove the faulty PSU while the server is running, then install the new PSU

Replace the PSU only after the server is fully powered off and grounded

Shut down the server, replace the PSU, and then power it back on

You are replacing a faulty system board in a PowerEdge server. After installing the new board, what is the first step before powering on the server?

Verify that all components (CPU, memory, expansion cards) are properly seated

Reconnect all power and data cables to the new board

Update the BIOS to the latest version

Check the iDRAC logs for any errors

Which tool provides out-of-band access to a PowerEdge server's hardware logs and diagnostics even when the operating system is not running?

OpenManage Server Administrator

A PowerEdge server emits a repeating beep pattern during POST. What is the primary purpose of this beep code?

To signal a successful POST and normal system operation

To communicate a hardware fault detected during the power-on self-test

To indicate the server is ready for operating system installation

To indicate that the system firmware is being updated

Dell PowerEdge Operate

Domain 3Objective 1

Troubleshoot Hardware Issues on a PowerEdge Server POWEREDGE-OPERATE-V2 Practice Questions (Page 1)

Part of the Troubleshooting domain, which accounts for 22% of the POWEREDGE-OPERATE-V2 exam.

27questions here

6free pages

5concepts

22%of the exam

Questions 1–5

1foundation · easy
After replacing a failed hard drive in a RAID array, what should you verify to confirm the system has fully recovered?
Select an answer first
2application · medium
You have identified a faulty power supply unit (PSU) in a PowerEdge R740 with redundant PSUs. The server is running critical workloads. What is the correct procedure to replace the PSU safely?
Select an answer first
3application · medium
You are replacing a faulty system board in a PowerEdge server. After installing the new board, what is the first step before powering on the server?
Select an answer first
4foundation · easy
Which tool provides out-of-band access to a PowerEdge server's hardware logs and diagnostics even when the operating system is not running?
Select an answer first
5foundation · easy
A PowerEdge server emits a repeating beep pattern during POST. What is the primary purpose of this beep code?
Select an answer first

Finished these 5 questions?

Review the revealed explanations, or continue through the curriculum.

Next 5 questions →Back to POWEREDGE-OPERATE-V2

Free Basic Practice is a study aid with revealable answers — not a scored exam. Examers.io is independent and not affiliated with or endorsed by Dell Technologies. “POWEREDGE-OPERATE-V2” is a trademark of its owner, used for identification only.