Configure Storage Sled Management, Mapping Drives, and Drive/enclosure Assigned Configuration POWEREDGE-MX-MODULAR-DEPLOY Practice Questions (Page 2)

Questions 6–10

1. 6application · medium

   An administrator is configuring a new MX7000 chassis with two storage sleds. The administrator needs to ensure that a specific set of drives in the front bays is used by the storage sled in slot SL1, and another set is used by the sled in slot SL2. The drives are currently unassigned. What is the correct procedure in OME-M?

   • ASelect the drives and assign them to the appropriate storage sled in the drive assignment settings.
   • BPhysically move the drives to the rear bays of the chassis for SL2, as front bays are only for SL1.
   • CConfigure the storage sleds in a daisy-chain so they share all drives equally.
   • DCreate virtual disks on each sled and the drives will automatically be assigned based on the RAID level.
   Reveal Solution Discussion Select an answer first
2. 7foundation · easy

   What is the purpose of mapping physical drives to virtual disks in a storage sled configuration?

   • ATo create logical storage devices that the operating system can use
   • BTo assign IP addresses to the drives
   • CTo enable remote management of the drives
   • DTo increase the physical capacity of the drives
   Reveal Solution Discussion Select an answer first
4. 8foundation · easy

   What does 'drive/enclosure assigned configuration' ensure in an MX7000 storage sled setup?

   • AThat all drives are assigned the same IP address for management
   • BThat enclosures are assigned to the chassis management module
   • CThat each drive is assigned to the correct storage sled or controller for proper ownership
   • DThat drives are automatically backed up to the cloud
   Reveal Solution Discussion Select an answer first
5. 9application · medium

   An administrator has a single storage sled in an MX7000 chassis and needs to present storage to two different host servers. The sled has 12 physical drives. The administrator wants to create two logical storage devices, each with 6 drives, and present one to each host. What is the required first step in OME-M to accomplish this?

   • ACreate a virtual disk using 6 of the physical drives, then create a second virtual disk with the remaining 6 drives.
   • BConfigure the storage sled in JBOD mode so each physical drive appears directly to both hosts.
   • CCreate a single RAID 0 virtual disk spanning all 12 drives and then partition it at the host level.
   • DAssign all 12 drives to the first host, then use the second host's HBA to split the drives logically.
   Reveal Solution Discussion Select an answer first
6. 10application · medium

   A company is deploying an MX7000 chassis and needs to ensure that a storage sled in slot SL1 manages a set of drives for a database workload, while a storage sled in slot SL4 manages a different set for a file server. The administrator has installed all drives in the front bays. What is the correct way to configure this in OME-M?

   • ACreate virtual disks on each sled and the drives will be automatically assigned based on the workload type.
   • BAssign the appropriate drive bays to each storage sled in the drive assignment settings.
   • CPhysically move the drives for the file server to the rear bays of the chassis.
   • DConfigure the storage sleds in a RAID group so they share all drives.
   Reveal Solution Discussion Select an answer first