Configure Storage Sled Management, Mapping Drives, and Drive/enclosure Assigned Configuration POWEREDGE-MX-MODULAR-DEPLOY Practice Questions (Page 1)

Questions 1–5

1. 1foundation · easy

   In the context of storage sled management, what does 'drive mapping' typically involve?

   • AConfiguring network routes for storage traffic
   • BAssigning drive letters to physical drives
   • CAssigning physical drives to specific virtual disks or logical volumes
   • DSetting drive spin-down timers for power savings
   Reveal Solution Discussion Select an answer first
2. 2foundation · easy

   Why is it important to assign drives to the correct storage sled or controller in an MX7000 chassis?

   • ATo reduce the power consumption of the chassis
   • BTo ensure the drives are visible to the intended compute sleds and avoid conflicts
   • CTo enable firmware updates for the drives
   • DTo increase the physical speed of the drives
   Reveal Solution Discussion Select an answer first
4. 3application · medium

   An administrator is troubleshooting a storage issue in an MX7000 chassis. A compute sled cannot see a virtual disk that was created on the storage sled in slot SL2. The administrator has verified that the virtual disk exists and is healthy. What is the most likely cause of the compute sled not seeing the virtual disk?

   • AThe compute sled's network connection is down.
   • BThe storage sled is in the wrong slot and must be moved to SL1.
   • CThe virtual disk has not been mapped to the compute sled.
   • DThe physical drives are not assigned to the storage sled.
   Reveal Solution Discussion Select an answer first
5. 4application · medium

   A data center administrator is setting up a new MX7000 chassis with two storage sleds. The administrator has created a virtual disk on the storage sled in slot SL1 and needs to ensure that only the compute sled in slot C1 can access this virtual disk. What must be configured in OME-M to enforce this access restriction?

   • AMap the virtual disk to the compute sled in slot C1 using the storage mapping feature.
   • BConfigure the virtual disk as a boot device for the compute sled in slot C1.
   • CPlace the compute sled in slot C1 into the same VLAN as the storage sled in SL1.
   • DAssign the physical drives of the virtual disk to slot C1 in the drive assignment settings.
   Reveal Solution Discussion Select an answer first
6. 5application · medium

   A company is deploying an MX7000 chassis with two storage sleds in slots SL2 and SL4. They need to ensure that all physical drives installed in the front drive bays of the chassis are visible to the storage sled in SL2 only, while the sled in SL4 should manage a separate set of drives for a different workload. The drives are physically installed in the chassis but not yet assigned. What should the administrator do in OpenManage Enterprise Modular (OME-M) to achieve this separation?

   • AAssign each physical drive bay to the storage sled in SL2 or SL4 using the drive assignment feature in OME-M.
   • BDisable the storage sled in SL4 and use only SL2, since two storage sleds cannot manage separate drive sets in the same chassis.
   • CConfigure the storage sled in SL4 to operate in passthrough mode so it only sees drives from the rear bays.
   • DPhysically move the drives for the SL4 workload into the sled's internal drive slots, as front bays are always owned by SL2.
   Reveal Solution Discussion Select an answer first