Perform Site Evaluation and Remediation Procedures. MIDRANGE-STORAGE-SOLUTIONS-DESIGN Practice Questions (Page 4)

Questions 16–20

1. 16expert · hard

   A Dell PowerStore system will be deployed in a data center with two separate network fabrics. The site evaluation shows that Fabric A has low latency and high bandwidth, while Fabric B has higher latency and lower bandwidth. The array will use both fabrics for redundancy. The storage administrator is concerned about performance during a failover. What should the remediation plan include?

   • AConfigure the array to use Fabric A as primary and Fabric B as backup
   • BUpgrade Fabric B to match Fabric A's performance characteristics
   • CUse Fabric A for all traffic and disable Fabric B
   • DAccept the performance difference because failover is rare
   Reveal Solution Discussion Select an answer first
2. 17foundation · medium

   Which network characteristic is most important to evaluate to ensure a Dell midrange storage system can handle expected data transfer volumes without bottlenecks?

   • ANetwork topology documentation
   • BNetwork bandwidth
   • CNetwork switch brand
   • DNetwork cable color
   Reveal Solution Discussion Select an answer first
4. 18foundation · medium

   Which action should be taken first when creating a remediation plan for a site that lacks adequate power for a Dell midrange storage system?

   • AIgnore the power issue and proceed with installation
   • BSchedule the storage installation immediately
   • CIdentify the specific power deficiency and its impact on the storage system
   • DOrder new storage hardware
   Reveal Solution Discussion Select an answer first
5. 19foundation · medium

   Which activity is part of executing remediation procedures for a site deficiency?

   • AUpdating the storage system's firmware
   • BCreating user accounts on the storage system
   • CInstalling additional power circuits to meet the storage system's requirements
   • DConfiguring the storage array's RAID settings
   Reveal Solution Discussion Select an answer first
6. 20application · medium

   A company is deploying a Dell PowerStore system that will replicate to a remote site. The site evaluation shows that the WAN link between the sites has adequate bandwidth but the latency is 150 ms, which exceeds the vendor's recommended maximum for synchronous replication. The company requires synchronous replication for this workload. What should the remediation plan include?

   • APlace the replication target at a third site with lower latency
   • BUpgrade the WAN link to a lower-latency connection, such as dedicated fiber
   • CConfigure asynchronous replication instead of synchronous
   • DIncrease the bandwidth on the existing WAN link
   Reveal Solution Discussion Select an answer first