An ECS installation fails, and you are examining the installation log. Which log entry would most likely indicate a network misconfiguration as the root cause?

WARNING: Disk /dev/sdb is almost full

INFO: NTP synchronization successful

ERROR: Unable to reach gateway 192.168.1.1

ERROR: Package 'ecs-core' not found

An ECS installation fails during the storage configuration step. The log shows that the system cannot create a RAID group because the disks have existing RAID metadata. The disks were previously used in another system. What should you do?

Ignore the error and continue the installation.

Replace the disks with new ones.

Clear the RAID metadata on the disks using the RAID controller's management utility.

Format the disks with a filesystem before installation.

During an ECS installation, which of the following is a typical failure point that can occur if the required VLANs are not properly configured on the physical switches?

Network misconfiguration preventing node communication

Incorrect time synchronization between nodes

Failure to meet the minimum disk space requirement

Insufficient memory on the management node

During an ECS installation, the deployment service fails to start on a node. The log shows that a required dependency, 'ecs-core', is not running. You check the service status and find that 'ecs-core' is disabled. What should you do?

Reboot the node and hope the service starts automatically.

Enable and start the 'ecs-core' service, then re-run the installation.

Reinstall the 'ecs-core' package from the installation media.

Modify the deployment service's configuration to not require 'ecs-core'.

Dell ECS Deploy

Domain 2Objective 5

Troubleshoot ECS Installation Issues ECS-DEPLOY Practice Questions (Page 4)

Part of the ECS Implementation domain, which accounts for 36% of the ECS-DEPLOY exam.

22questions here

5free pages

7concepts

36%of the exam

Questions 16–20

16foundation · easy
Which of the following is a software dependency that must be installed before ECS installation can proceed?
Select an answer first
17foundation · easy
An ECS installation fails, and you are examining the installation log. Which log entry would most likely indicate a network misconfiguration as the root cause?
Select an answer first
18application · medium
An ECS installation fails during the storage configuration step. The log shows that the system cannot create a RAID group because the disks have existing RAID metadata. The disks were previously used in another system. What should you do?
Select an answer first
19foundation · easy
During an ECS installation, which of the following is a typical failure point that can occur if the required VLANs are not properly configured on the physical switches?
Select an answer first
20application · easy
During an ECS installation, the deployment service fails to start on a node. The log shows that a required dependency, 'ecs-core', is not running. You check the service status and find that 'ecs-core' is disabled. What should you do?
Select an answer first

Finished these 5 questions?

Review the revealed explanations, or continue through the curriculum.

Next 5 questions →Back to ECS-DEPLOY

Free Basic Practice is a study aid with revealable answers — not a scored exam. Examers.io is independent and not affiliated with or endorsed by Dell Technologies. “ECS-DEPLOY” is a trademark of its owner, used for identification only.