During the ECS installation process, the administrator is prompted to configure the initial settings. Which settings are typically configured at this stage?

Network interfaces and hostname.

Storage pool and replication factor.

After installing ECS on a node, the administrator notices that the node is not appearing in the cluster. Which log or status check should the administrator perform to diagnose the issue?

Verify that the node's hostname is correct.

Check the ECS installation logs for errors.

Check the node's physical connection to the network switch.

Restart the node and see if it appears.

After installing ECS on a node, the administrator wants to verify that the installation was successful by checking the system status. Which command or action would provide the most comprehensive verification?

Verify that the ECS service is running.

Run the ECS status command to check the health of the node.

After installing ECS on a node, the administrator needs to configure the network interfaces so that the node can communicate with other cluster nodes. Which initial configuration task should be performed?

Assign IP addresses to the management and storage interfaces.

Set the hostname to match the storage pool name.

Enable the firewall on all interfaces.

A storage administrator is preparing to install ECS on a new cluster of physical nodes. The nodes have been racked and cabled, and the administrator has verified that each node meets the hardware requirements. However, the administrator is unsure whether the network infrastructure is ready. Which prerequisite must be verified before beginning the installation?

All nodes have a direct internet connection to download the ECS software.

The management and storage networks are on separate VLANs with sufficient bandwidth and low latency.

A DNS server is configured to resolve the short hostnames of all nodes.

All nodes have a public IP address assigned to the management interface.

Dell ECS Deploy

Domain 2Objective 3

Perform ECS Software Installation ECS-DEPLOY Practice Questions (Page 4)

Part of the ECS Implementation domain, which accounts for 36% of the ECS-DEPLOY exam.

23questions here

5free pages

5concepts

36%of the exam

Questions 16–20

16application · medium
During the ECS installation process, the administrator is prompted to configure the initial settings. Which settings are typically configured at this stage?
Select an answer first
17application · medium
After installing ECS on a node, the administrator notices that the node is not appearing in the cluster. Which log or status check should the administrator perform to diagnose the issue?
Select an answer first
18application · medium
After installing ECS on a node, the administrator wants to verify that the installation was successful by checking the system status. Which command or action would provide the most comprehensive verification?
Select an answer first
19application · medium
After installing ECS on a node, the administrator needs to configure the network interfaces so that the node can communicate with other cluster nodes. Which initial configuration task should be performed?
Select an answer first
20application · medium
A storage administrator is preparing to install ECS on a new cluster of physical nodes. The nodes have been racked and cabled, and the administrator has verified that each node meets the hardware requirements. However, the administrator is unsure whether the network infrastructure is ready. Which prerequisite must be verified before beginning the installation?
Select an answer first

Finished these 5 questions?

Review the revealed explanations, or continue through the curriculum.

Next 5 questions →Back to ECS-DEPLOY

Free Basic Practice is a study aid with revealable answers — not a scored exam. Examers.io is independent and not affiliated with or endorsed by Dell Technologies. “ECS-DEPLOY” is a trademark of its owner, used for identification only.