An ECS deployment must comply with a security policy that requires management traffic to be isolated from both storage and client traffic. The node has three NICs. The administrator has assigned VLAN 100 to management, VLAN 200 to storage, and VLAN 300 to client. However, after configuration, the management interface cannot reach the management gateway. The routing table shows a default route via the storage gateway. What is the most likely cause?

The default route is incorrectly set to the storage gateway, so management traffic is being sent to the wrong gateway.

The storage VLAN is not properly tagged on the switch port.

The client network is using the same subnet as the management network.

The management interface is not assigned an IP address in the management subnet.

What is the purpose of configuring routing in an ECS deployment?

To assign IP addresses to the ECS nodes

To provide redundancy for the storage network

To enable communication between ECS nodes and external networks

To isolate management traffic from client traffic

Which network segments are typically separated in an ECS deployment?

Management, storage, and client

Dell ECS Deploy

Domain 2Objective 2

Install the ECS Core OS and Configure Network Separation and Network Configuration ECS-DEPLOY Practice Questions (Page 3)

Part of the ECS Implementation domain, which accounts for 36% of the ECS-DEPLOY exam.

22questions here

5free pages

5concepts

36%of the exam

Questions 11–15

11expert · hard
An ECS deployment must comply with a security policy that requires management traffic to be isolated from both storage and client traffic. The node has three NICs. The administrator has assigned VLAN 100 to management, VLAN 200 to storage, and VLAN 300 to client. However, after configuration, the management interface cannot reach the management gateway. The routing table shows a default route via the storage gateway. What is the most likely cause?
Select an answer first
12foundation · easy
What is the purpose of configuring routing in an ECS deployment?
Select an answer first
13application · medium
After configuring the ECS core OS and network settings, an administrator wants to verify that the VLAN subinterface for the storage network is operational. Which command will show the VLAN subinterface and its assigned IP address?
Select an answer first
14foundation · easy
Which network segments are typically separated in an ECS deployment?
Select an answer first
15foundation · easy
Which command is commonly used to verify network connectivity between ECS nodes?
Select an answer first

Finished these 5 questions?

Review the revealed explanations, or continue through the curriculum.

Next 5 questions →Back to ECS-DEPLOY

Free Basic Practice is a study aid with revealable answers — not a scored exam. Examers.io is independent and not affiliated with or endorsed by Dell Technologies. “ECS-DEPLOY” is a trademark of its owner, used for identification only.

Install the ECS Core OS and Configure Network Separation and Network Configuration ECS-DEPLOY Practice Questions (Page 3)

Questions 11–15

What is the purpose of configuring routing in an ECS deployment?

After configuring the ECS core OS and network settings, an administrator wants to verify that the VLAN subinterface for the storage network is operational. Which command will show the VLAN subinterface and its assigned IP address?

Which network segments are typically separated in an ECS deployment?

Which command is commonly used to verify network connectivity between ECS nodes?

Keep studying — ECS Implementation