Explain the Node Replacement and Node Addition Processes AVAMAR-DEPLOY Practice Questions (Page 2)

Questions 6–10

1. 6application · medium

   An administrator is adding a new Data Node to an Avamar grid to expand capacity. The node has been physically installed, powered on, and its network settings are configured. What is the NEXT step in the node addition procedure?

   • ARun the avmaint checknode command to verify the node's hardware and software status.
   • BRun the avmaint nodeadd command to add the new node to the grid.
   • CRun the avmaint activate command to activate the new node's licenses.
   • DRun the avmaint sync command to synchronize the new node's data with the grid.
   Reveal Solution Discussion Select an answer first
2. 7foundation · easy

   What is the first step in the node replacement procedure for an Avamar grid?

   • AInstall the replacement node's operating system.
   • BRun the avsetup utility on the replacement node.
   • CShut down the failed node gracefully.
   • DRemove the failed node from the Avamar grid using the MCS.
   Reveal Solution Discussion Select an answer first
4. 8foundation · easy

   During node addition, what is a key capacity expansion consideration?

   • AThe new node must be added to the same RAID group as existing nodes.
   • BThe new node reduces the number of RAID groups in the grid.
   • CThe new node increases the total storage capacity of the grid.
   • DThe new node requires a separate backup schedule.
   Reveal Solution Discussion Select an answer first
5. 9expert · hard

   A Data Node in an Avamar grid has failed. The administrator has a replacement node with the same hardware but a different firmware version. What is the CORRECT course of action?

   • AUpdate the replacement node's firmware to match the grid's firmware version before installing it.
   • BInstall the replacement node with the different firmware and then run the avmaint firmware command to update it.
   • CInstall the replacement node with the different firmware and then upgrade the entire grid's firmware to match.
   • DInstall the replacement node with the different firmware and add it to the grid; the grid will handle the firmware update.
   Reveal Solution Discussion Select an answer first
6. 10foundation · easy

   After physically installing the replacement node, which logical step is performed to integrate it into the Avamar grid?

   • ARun the Avamar installation and configuration utility (avsetup).
   • BManually assign the node's IP address to match the failed node.
   • CReboot the replacement node to load the Avamar software.
   • DCopy the failed node's data from backup to the replacement node.
   Reveal Solution Discussion Select an answer first