Configure and Run Avamar Replication Solutions AVAMAR-DEPLOY Practice Questions (Page 6)

Questions 26–29

1. 26foundation · easy

   What does a replication policy in Avamar define?

   • AThe authentication method for the destination system
   • BThe network bandwidth used for replication
   • CThe storage capacity of the destination system
   • DWhich datasets are replicated and when
   Reveal Solution Discussion Select an answer first
2. 27application · medium

   An administrator is planning to configure replication between two Avamar systems. The primary system is in a data center, and the secondary system is in a cloud environment. The administrator needs to ensure that replication traffic is encrypted. What should the administrator do?

   • ASet a bandwidth throttle on the replication schedule.
   • BConfigure replication to use SSL/TLS encryption.
   • CUse a VPN tunnel between the two systems.
   • DEnsure that the network link is a dedicated private line.
   Reveal Solution Discussion Select an answer first
4. 28application · medium

   An administrator has configured replication between two Avamar systems. The replication job status shows 'completed with warnings'. What should the administrator do to investigate the warnings?

   • ARun a validation job on the destination system.
   • BRestart the replication schedule.
   • CReview the replication job log for the specific warnings.
   • DCheck the network connectivity between the systems.
   Reveal Solution Discussion Select an answer first
5. 29application · medium

   A company runs two Avamar systems: a primary at the headquarters and a secondary at a disaster recovery site. The network link between them is a 100 Mbps WAN with a 50 Mbps committed information rate. The administrator needs to configure replication so that the secondary system can receive data, but the replication must not saturate the WAN link. What should the administrator do first?

   • AIncrease the WAN link's committed information rate to 100 Mbps.
   • BSet a bandwidth throttle on the primary system's network interface.
   • CConfigure the secondary system as a replication destination and set a bandwidth throttle on the replication schedule.
   • DConfigure the primary system as a replication destination for the secondary system.
   Reveal Solution Discussion Select an answer first