Configure and Run Avamar Replication Solutions AVAMAR-DEPLOY Practice Questions (Page 3)

Questions 11–15

1. 11foundation · easy

   What is the purpose of a failback in Avamar replication?

   • ATo delete the replicated data from the destination system
   • BTo configure a new replication schedule
   • CTo replicate data from the destination back to the source
   • DTo return operations to the primary system after it has been restored
   Reveal Solution Discussion Select an answer first
2. 12application · medium

   A replication job between two Avamar systems fails with an authentication error. The administrator has verified that the network is reachable and the remote system is online. What should the administrator check next?

   • AVerify that the replication user credentials are correct on both systems.
   • BCheck the disk space on the destination system.
   • CReboot the primary Avamar system.
   • DEnsure the replication schedule is enabled.
   Reveal Solution Discussion Select an answer first
4. 13application · medium

   An administrator is setting up replication between two Avamar systems. The administrator has added the remote system as a replication destination, but the connection test fails. What should the administrator check first?

   • ACheck the disk space on the remote system.
   • BRestart the Avamar services on the local system.
   • CVerify that the remote system is reachable over the network and that the required ports are open.
   • DEnsure that the replication schedule is enabled.
   Reveal Solution Discussion Select an answer first
5. 14application · medium

   After configuring replication between two Avamar systems, the administrator wants to verify that the replicated data is consistent and complete. Which action should the administrator take?

   • AReview the replication logs on the primary system only.
   • BPerform a test restore from the secondary system.
   • CCompare the total backup size on the primary and secondary systems.
   • DCheck the replication status in the Avamar Management Console and run a validation job on the secondary system.
   Reveal Solution Discussion Select an answer first
6. 15expert · hard

   A company has a primary Avamar system and a replicated system at a disaster recovery site. The primary system fails, and the administrator performs a failover to the replicated system. After the failover, the administrator wants to ensure that the replicated system is functioning correctly as the primary. What should the administrator do?

   • AVerify that the original primary system is still reachable.
   • BRun a test backup and restore on the replicated system.
   • CReconfigure the replication schedule on the replicated system.
   • DCheck the replication status on the replicated system.
   Reveal Solution Discussion Select an answer first