Troubleshoot High Availability CCA-APPDS-TRAFFIC-MANAGEMENT Practice Questions (Page 2)

Questions 6–10

1. 6foundation · easy

   What is the primary purpose of the heartbeat mechanism in a Citrix ADC HA pair?

   • ATo synchronize configuration changes between nodes.
   • BTo load balance traffic between the two nodes.
   • CTo detect the health and availability of the peer node.
   • DTo encrypt communication between the nodes.
   Reveal Solution Discussion Select an answer first
2. 7application · medium

   A Citrix ADC HA pair is in a 'STAYSECONDARY' state. The administrator has verified that the primary node is healthy and the heartbeat is working. The secondary node's configuration appears to be out of sync. What is the most appropriate action to resolve this state and restore the pair to normal operation?

   • ARun 'force ha failover' on the primary node to force the secondary to become primary and re-sync.
   • BRun 'force sync' on the primary node to push the correct configuration to the secondary.
   • CDisable and re-enable HA on the secondary node to trigger a full re-synchronization.
   • DReboot the secondary node to clear the STAYSECONDARY state and force a fresh sync.
   Reveal Solution Discussion Select an answer first
4. 8foundation · easy

   Which condition can cause partial configuration propagation to the secondary node in an HA pair?

   • AThe secondary node is temporarily unreachable during propagation.
   • BThe secondary node has a different firmware version.
   • CThe primary node has a higher priority than the secondary.
   • DThe HA pair is in a primary-secondary state.
   Reveal Solution Discussion Select an answer first
5. 9foundation · easy

   A Citrix ADC HA pair is not failing over when the primary node loses network connectivity. Which common failure scenario is most likely causing this issue?

   • AThe HA pair is configured in active-active mode instead of active-passive.
   • BThe primary node's interfaces are not monitored by HA, so the loss is not detected.
   • CThe secondary node has a higher priority than the primary.
   • DThe secondary node is not configured with the same VLANs as the primary.
   Reveal Solution Discussion Select an answer first
6. 10application · medium

   An HA pair is experiencing frequent, unexplained failovers. The administrator has verified that the heartbeat is stable and the configuration is synchronized. The 'show ha status' output shows the pair is in a 'PRIMARY' and 'SECONDARY' state, but failovers occur every few minutes. What is the most likely cause to investigate next?

   • AThe HA heartbeat is being sent on the wrong interface.
   • BThe secondary node is overloaded and is failing health checks.
   • CThe HA pair is in a 'STAYSECONDARY' state due to a configuration mismatch.
   • DThe interface monitoring is configured on an interface that is flapping.
   Reveal Solution Discussion Select an answer first