What is the primary purpose of configuring two NetScaler appliances as a High Availability (HA) pair?

To allow both appliances to share the same configuration and load-balance traffic between them.

To enable the appliances to be managed from a single IP address for administrative convenience.

To provide redundancy so that if one node fails, the other node can take over traffic processing.

To increase the total throughput by combining the processing power of both appliances.

Which condition is a common cause of a split-brain scenario in a NetScaler HA pair?

The primary node has a higher priority than the secondary.

The secondary node fails to synchronize its configuration.

The HA pair is configured with different subnet masks.

Both nodes become active simultaneously because they cannot communicate with each other.

A company is setting up a new NetScaler HA pair. The administrator wants to ensure that the secondary node automatically takes over if the primary node's data interfaces fail. What must be configured?

Failover threshold on the primary node.

Interface monitoring on the primary node.

Service monitoring on the secondary node.

Heartbeat interval on both nodes.

What is the purpose of a forced failover during maintenance of an HA pair?

To test the failover process without affecting traffic.

To intentionally make the secondary node active so the primary can be taken offline for maintenance.

To permanently change the primary node to the secondary.

To synchronize the configuration before maintenance.

CitrixCertified Associate – App Delivery and Security (CCA-AppDS) – Traffic Management

Domain 4Objective 1

Set up and Manage a NetScaler High Availability Pair CCA-APPDS-TRAFFIC-MANAGEMENT Practice Questions (Page 3)

Part of the Domain 4: High Availability domain, which makes up ~7% of our current practice bank.

18questions here

4free pages

6concepts

Questions 11–15

11foundation · easy
What is the primary purpose of configuring two NetScaler appliances as a High Availability (HA) pair?
Select an answer first
12foundation · easy
Which condition is a common cause of a split-brain scenario in a NetScaler HA pair?
Select an answer first
13application · medium
A company is setting up a new NetScaler HA pair. The administrator wants to ensure that the secondary node automatically takes over if the primary node's data interfaces fail. What must be configured?
Select an answer first
14foundation · easy
Which of the following is propagated from the primary node to the secondary node during HA synchronization?
Select an answer first
15foundation · easy
What is the purpose of a forced failover during maintenance of an HA pair?
Select an answer first

Finished these 5 questions?

Review the revealed explanations, or continue through the curriculum.

Next 5 questions →Back to CCA-APPDS-TRAFFIC-MANAGEMENT

Free Basic Practice is a study aid with revealable answers — not a scored exam. Examers.io is independent and not affiliated with or endorsed by Citrix. “CCA-APPDS-TRAFFIC-MANAGEMENT” is a trademark of its owner, used for identification only.