What is the primary purpose of a BGP route reflector?

To provide authentication for BGP sessions

To translate between IPv4 and IPv6 BGP routes

To reduce the number of BGP sessions in a full mesh

To filter BGP routes based on community attributes

A data center engineer is troubleshooting an OSPFv2 adjacency issue between two Nexus switches. The interfaces are up, and both switches have the same OSPF area and network type. However, the adjacency is stuck in the EXSTART state. What is the most likely cause?

The OSPF area is not configured on the interface.

The OSPF router IDs are the same on both switches.

The MTU is mismatched between the two interfaces.

The OSPF hello and dead timers are mismatched.

What is the primary purpose of a First Hop Redundancy Protocol (FHRP) like HSRP or VRRP?

To load balance traffic across multiple WAN links

To filter malicious traffic at the gateway

To provide a virtual default gateway that remains available if the physical gateway fails

To encrypt traffic between hosts and the gateway

CiscoCertified Network Professional Data Center

Domain 1Objective 1

1.1 Apply Routing Protocols 350-601 Practice Questions (Page 4)

Part of the Network domain, which accounts for 25% of the 350-601 exam. Cisco does not publish an official question count, but from its 120-minute exam (~50–80 total, ~13–20 in this domain), expect 1–2 from this objective — we provide 23 practice questions to prepare you well beyond it. (estimate)

23questions here

5free pages

9concepts

25%of the exam

Questions 16–20

16foundation · easy
What is the primary purpose of a BGP route reflector?
Select an answer first
17application · medium
A data center engineer is troubleshooting an OSPFv2 adjacency issue between two Nexus switches. The interfaces are up, and both switches have the same OSPF area and network type. However, the adjacency is stuck in the EXSTART state. What is the most likely cause?
Select an answer first
18foundation · easy
What is the primary purpose of a First Hop Redundancy Protocol (FHRP) like HSRP or VRRP?
Select an answer first
19foundation · easy
In OSPFv3, which field is used to identify the address family (IPv4 or IPv6) when using address-family configuration?
Select an answer first
20foundation · easy
Which BGP feature allows multiple neighbors to share the same configuration parameters, simplifying configuration and reducing errors?
Select an answer first

Finished these 5 questions?

Review the revealed explanations, or continue through the curriculum.

Next 5 questions →Back to 350-601

Free Basic Practice is a study aid with revealable answers — not a scored exam. Examers.io is independent and not affiliated with or endorsed by Cisco. “350-601” is a trademark of its owner, used for identification only.

1.1 Apply Routing Protocols 350-601 Practice Questions (Page 4)

Questions 16–20

What is the primary purpose of a BGP route reflector?

A data center engineer is troubleshooting an OSPFv2 adjacency issue between two Nexus switches. The interfaces are up, and both switches have the same OSPF area and network type. However, the adjacency is stuck in the EXSTART state. What is the most likely cause?

What is the primary purpose of a First Hop Redundancy Protocol (FHRP) like HSRP or VRRP?

In OSPFv3, which field is used to identify the address family (IPv4 or IPv6) when using address-family configuration?

Which BGP feature allows multiple neighbors to share the same configuration parameters, simplifying configuration and reducing errors?

Keep studying — Network