1.1 Apply Routing Protocols 350-601 Practice Questions (Page 3)

Questions 11–15

1. 11foundation · easy

   In HSRP, which parameter is used to determine which router becomes the active router?

   • AStandby group number
   • BHello interval
   • CMAC address
   • DPriority
   Reveal Solution Discussion Select an answer first
2. 12foundation · easy

   Which HSRP feature allows a router to take over as active immediately when its priority is higher than the current active router?

   • APreemption
   • BTracking
   • CAuthentication
   • DHello timer
   Reveal Solution Discussion Select an answer first
4. 13foundation · easy

   Which command is used to configure a static rendezvous point (RP) for a multicast group range in PIM?

   • Aip pim sparse-mode
   • Bip pim bsr-candidate <interface>
   • Cip pim send-rp-announce <interface> scope <ttl>
   • Dip pim rp-address <ip-address> [<access-list>]
   Reveal Solution Discussion Select an answer first
5. 14foundation · easy

   In PIM sparse mode, what is the role of a Rendezvous Point (RP)?

   • ATo act as the root of the shared tree for multicast groups
   • BTo perform RPF checks on multicast packets
   • CTo flood multicast traffic to all routers in the network
   • DTo translate multicast addresses to unicast addresses
   Reveal Solution Discussion Select an answer first
6. 15foundation · easy

   Which statement correctly describes a key difference between OSPFv2 and OSPFv3?

   • AOSPFv3 does not support multiple instances per link.
   • BOSPFv3 runs directly over IPv6 and does not require IPv4 addresses on interfaces.
   • COSPFv3 uses the same LSA types as OSPFv2, including Type 2 for network LSAs.
   • DOSPFv3 uses a 64-bit router ID, while OSPFv2 uses a 32-bit router ID.
   Reveal Solution Discussion Select an answer first