4.6 Configure and Verify NETCONF and RESTCONF 350-401 Practice Questions (Page 9)

Questions 41–43

1. 41application · medium

   A network engineer has enabled RESTCONF on a Cisco IOS XE device and wants to verify that the RESTCONF server is operational. Which command should the engineer use?

   • Ashow ip http server status
   • Bshow netconf-yang
   • Cshow running-config | include restconf
   • Dshow restconf
   Reveal Solution Discussion Select an answer first
2. 42application · medium

   A developer is using RESTCONF to create a new loopback interface on a Cisco IOS XE device. The developer sends a POST request to the collection URI for interfaces. What is the expected result if the request is successful?

   • AThe device creates the new loopback interface and returns a 201 Created status.
   • BThe device replaces an existing interface and returns a 200 OK status.
   • CThe device returns a 405 Method Not Allowed error.
   • DThe device returns a 204 No Content status without creating the interface.
   Reveal Solution Discussion Select an answer first
3. 43foundation · easy

   What is the primary purpose of the NETCONF protocol?

   • ATo enable real-time streaming of telemetry data from network devices.
   • BTo replace SNMP for monitoring network performance metrics.
   • CTo provide a web-based GUI for network device management.
   • DTo provide a standardized way to install, manipulate, and delete the configuration of network devices.
   Reveal Solution Discussion Select an answer first