1.2 Deploy FlexConnect Capabilities 300-430 Practice Questions (Page 1)

Questions 1–5

1. 1application · medium

   A FlexConnect AP at a remote site has lost connectivity to the WLC. The AP is configured with a local VLAN for data and a central-switched VLAN for voice. The administrator wants to ensure that voice clients can still make calls during the outage. What should be configured in advance?

   • AEnable FlexConnect ACLs to allow voice traffic to be forwarded locally even if the VLAN is central-switched.
   • BConfigure the voice VLAN for local switching as well, so the AP can switch voice traffic locally in standalone mode.
   • CConfigure a backup WLC so the AP can maintain the CAPWAP tunnel for voice traffic.
   • DEnsure the voice VLAN is configured for central switching, and the AP will automatically fall back to local switching.
   Reveal Solution Discussion Select an answer first
2. 2expert · hard

   A branch office has a FlexConnect AP with two SSIDs: one for employees and one for guests. The employee SSID is locally switched, and the guest SSID is centrally switched. The security policy requires that guest clients cannot access the employee subnet. The administrator wants to enforce this policy at the AP to avoid unnecessary WAN traffic. Which configuration should be used?

   • AApply a VLAN ACL on the upstream switch for the employee VLAN.
   • BApply an ACL on the controller's VLAN interface to block guest-to-employee traffic.
   • CConfigure the guest SSID for local switching and apply an ACL on the AP.
   • DApply a FlexConnect ACL to the guest SSID on the AP to block traffic to the employee subnet.
   Reveal Solution Discussion Select an answer first
4. 3application · medium

   A company has FlexConnect APs at remote sites connected over a low-bandwidth WAN. The APs need to be upgraded to a new software version, but the WAN link is too slow to download the image from the controller for each AP. The administrator wants to minimize WAN bandwidth usage during the upgrade. What should the administrator do?

   • AUse FTP to transfer the image to each AP from the controller.
   • BUse the Smart AP image upgrade feature to allow APs to download the image from a local source or peer APs.
   • CDownload the image to each AP individually from the controller over the WAN.
   • DUpgrade the APs one at a time and hope the WAN link can handle it.
   Reveal Solution Discussion Select an answer first
5. 4expert · hard

   A company has two buildings, each with its own FlexConnect group. A user roams from an AP in Building A to an AP in Building B. The user is on a VLAN that is locally switched in both buildings. Which statement best describes the roaming behavior?

   • AThe client roams between the two APs, and the controller is involved in the roaming decision because the APs are in different FlexConnect groups.
   • BThe client roams locally between the two APs, and the controller is not involved.
   • CThe client cannot roam between the two buildings because the VLAN is locally switched.
   • DThe client will be disconnected and must reassociate with the new AP.
   Reveal Solution Discussion Select an answer first
6. 5application · medium

   A retail chain has 15 FlexConnect APs across three stores, each with its own VLANs and SSIDs. The WAN link to the controller is unreliable, and the network team wants to minimize the impact of a WAN outage on client roaming. The APs in each store should be able to support client roaming without involving the controller when the WAN is down. What should the network team configure?

   • ACreate a separate FlexConnect group for each store and configure the same VLANs and SSIDs on each group.
   • BUse central switching for all SSIDs and rely on the controller for roaming decisions.
   • CConfigure each AP as a standalone FlexConnect AP without any group membership.
   • DPlace all APs in a single FlexConnect group and enable local switching for all SSIDs.
   Reveal Solution Discussion Select an answer first