CiscoCertified Network Associate (CCNA)
Domain 3Objective 4
3.4 Configure and Verify Single Area OSPFv2 200-301 Practice Questions (Page 3)
Part of the IP Connectivity domain, which accounts for 25% of the 200-301 exam. Cisco does not publish an official question count, but from its 120-minute exam (~50–80 total, ~13–20 in this domain), expect 3–4 from this objective — we provide 31 practice questions to prepare you well beyond it. (estimate)
31questions here
7free pages
8concepts
25%of the exam
Questions 11–15
- 11
Two OSPFv2 routers on the same Ethernet segment have different Hello and Dead intervals. What is the most likely result?
Select an answer first - 12
Which OSPFv2 neighbor state indicates that both routers have exchanged Database Description (DBD) packets and are now sending Link-State Request (LSR) packets to request missing link-state advertisements?
Select an answer first - 13
A network engineer is configuring OSPFv2 on two routers connected over an Ethernet link. The engineer verifies that both routers are in area 0, have the same Hello and Dead intervals, and use the same authentication settings. However, the neighbor adjacency does not form. What additional parameter must match for the adjacency to form?
Select an answer first - 14
Two Cisco routers are connected via a point-to-point serial link. The engineer configures OSPFv2 on both routers, but the adjacency does not form. The engineer verifies that the Hello and Dead intervals match, the area ID is the same, and authentication is disabled. What is the next most likely parameter to check?
Select an answer first - 15
What is the default OSPFv2 Dead interval on a broadcast multiaccess network?
Select an answer first
Finished these 5 questions?
Review the revealed explanations, or continue through the curriculum.
Free Basic Practice is a study aid with revealable answers — not a scored exam. Examers.io is independent and not affiliated with or endorsed by Cisco. “200-301” is a trademark of its owner, used for identification only.